Main Menu Functions

CMY Zoom 575™

0. ADDRESS MENU

- AOO1 - A511 (Value) - This is where you set the fixtures DMX address.

Setting/Changing the DMX Address

After applying power to the CMY ZOOM 575™ the LED will display the fixture’s current DMX address immediately after the reset sequence. If the fixture is not receiving a DMX signal the display will flash continuously. To set or adjust a DMX address, please follow the procedure below:

1.Switch on the CMY ZOOM 575™ and wait for the fixture reset process to finished.

2.Press the Mode/Esc button to access the main menu. Toggle through the menu by pressing the Up and Down buttons until the display shows A001. Tap the enter button to make changes to the address, the current three digit address will immediately begin to flash.

3.While the current three-digit address is flashing, use the UP and DOWN buttons to select adjust the address. Lock your new address into the unit’s memory by pressing the Enter button. After the new address has been successfully stored into the fixture’s memory the LED will briefly readout PASS.

The DMX address is non-destructible and will remain in the fixture’s memory even when power to the fixture has been switched off. Memory is backed-up and retained by an internal power source with a five year shelf life.

1. TEST MENU

- T-01 - T -XX(Test) - T ests the functions of each channel. There are 10 DMX channels, and all channels except channel 3, 6, and 10 can be tested. To enter the test menu follow the procedure below:

1.Access the main menu.

2.Tap the UP button until “TEST” is displayed, press ENTER.

3.The display will show T-01. You can now press the up button and test the different channels. For example: If you press the up button until “T-03” is displayed, the unit

CMY Zoom 575™