CMY Zoom 575™
2 to a value of “7” and use channel 3 to set your address to 57 by selecting a channel value of 57. Example 2: If you want to set the starting address to 420, set channel 1 to a value of “7,” channel 2 to "8" and channel 3 to "164" (256+164=420).
4.Wait for approximately 20 seconds for the unit to complete the address reset function.
DLOF
– This feature allows you to control the lamp via DMX.
1.Access the main menu.
2.Tap the UP button until “SPEC” is displayed, press ENTER.
3.Tap the UP button until “DLOF” is displayed, press ENTER.
4.The display will show “ON/OFF.”
5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.
6.Press ENTER to confirm.
7.Press MODE/ESC to return to the main menu.
DLAY
– This function allows the user to set a lamp “strike” delay time.
1.Access the main menu.
2.Tap the UP button until “SPEC” is displayed, press ENTER.
3.Tap the UP button until “DLAY” is displayed, press ENTER.
4.The display will show
5.Press the UP and DOWN buttons to adjust the delay time.
6.When completed press ENTER to confirm.
7.Press MODE/ESC to return to the main menu.
SPOT
– This function allows you to optimize the lamp without the use of an external DMX controller. In this mode, the device will not react to any control signal.
©Elation Professional® | 32 | CMY Zoom 575™ |