EdgeStar AP12005ECO Operating the Remote Control, Power, Cooling Mode, Dehumidifying Mode

Operating the Remote Control

Power	Use the	Power button to turn the portable air conditioner on and off.
	By default when you first use the power button, the unit will begin to
	operate in cooling mode and the front panel will be illuminated in blue.
	The unit will remember the last used mode/settings if you shut down and
	restart.
	Auto-Restart:If power to the unit is interrupted, the air conditioner will
	restart itself in its last used mode/settings once power is restored. The
	compressor will restart after 3 minutes.
Cooling Mode	Cooling mode cools and dehumidifies the air. If the ambient temperature
	drops below the temperature you selected, the compressor turns off and

the unit functions with the fan only. When the temperature rises above the temperature you selected, the compressor turns on again. The front panel lights will be blue.

Whether your desired temperature can actually be reached depends on the ambient conditions. The room temperature remaining above the set temperature is normal.

To operate the unit in cooling mode:

1)Make sure the power cord is plugged into a power outlet.

2)Press the Power button on the remote control.

3)Press the Mode button until the cooling indicator is selected.

4)Select the fan speed by using the Speed button.

	NOTE: The exhaust hose	5) Set the thermostat by using the	Up and	Down buttons. The
	must be used in Cooling	thermostat is adjustable between 64°F - 90°F in one degree increments.
	mode in order to cool a room.	You can switch between Fahrenheit and Celsius by pressing the
		button.
Dehumidifying Mode		During the Dehumidifying mode, the unit will condense water out of the air
		and exhaust it through the exhaust hose. The ambient temperature in the
		room will probably drop by a few degrees while using the Dehumidifying
		mode. The front panel lights will be yellow.

To operate the unit in dehumidifying mode:

1)Make sure the power cord is plugged into a power outlet.

2)Press the Power button on the remote control.

3)Press the Mode button until the dehumidify indicator is selected.

NOTES: If the room temperature is below 77ºF, the fan will always run on low speed while in the Dehumidifying mode. If you do not use the exhaust hose in Dehumidifying mode, you must manually drain the water from the unit. Additionally, the ambient temperature in the room will probably rise by a few degrees if you do not use the exhaust hose. You will not be able to change the thermostat temperature while in Dehumidifying Mode.

EdgeStar Portable Air Conditioner 12