EdgeStar AP10001B Cleaning the unit, Cleaning the pre-filters, Preparation for Storage

Cleaning the unit	Use a soft dry cloth to wipe the body clean. If necessary, use lukewarm
	water to dampen a cloth to clean the unit.
	Use a soft bristle brush to clean between the vents.
	Carefully use a vacuum cleaner to clean the condenser coils
	Never use abrasive chemicals, volatile substances, gasoline, detergents,
	chemically treated cloths, or other cleaning solvents that may damage the
	cabinet exterior.
	Never spray water directly on the unit.
Cleaning the pre-filters	Clean the pre-filters periodically to prolong the unit’s life, and keep
	the unit running efficiently. Lint, dust, and dirt can clog the unit and
	reduce its performance and effectiveness. If the unit is used in a
	dusty environment you may need to clean it on a weekly basis.
	To clean the pre-filters, follow the steps below:
	1) Power off the unit and remove the pre-filters.

	2)		Remove the activated carbon filter from the top pre-filter, if
	present.
	3)	Use a vacuum cleaner or tap the filter lightly to remove loose
NOTE: The activated carbon
	dust and dirt, then rinse thoroughly under lukewarm running water
filter is not washable. You
	(below 104°F). You may use a mild soap and water solution if
should replace it every 2-3
	needed. Allow the pre-filter to air dry in a cool and shaded place.
months or as needed. Contact
EdgeStar retailers for	Dry thoroughly before reinstalling.
replacement filters.	Warning: Never operate the unit without the filters.
Preparation for Storage	If you are not going to be using the unit for an extended period of
	time, follow the instructions below before storing your unit:
	1)	Drain all the water from the unit’s reservoir. Operate the unit in
	fan mode for a few hours to thoroughly dry any moisture left on the
	coils inside the unit.
	2)	Power off the unit, and clean or change the filters.
	3)	Unplug and carefully wind the power cord.
	4)	Remove the exhaust hose and duct connectors and keep them

in a safe place.

15