Oreck DTX warranty Warranty, Troubleshooting Guide

Page 3

E N G L I S H

Warranty

ORECK MANUFACTURING COMPANY: (ORECK gives you the following limited warranty for this product only if it was originally purchased for use, not resale, from ORECK or an ORECK Authorized Retail Dealer.)

ORECK will repair or replace, free of charge, to the original purchaser, any part which is found to be defective in material or workmanship within three (3) years of the date of purchase; ten (10) years on motor. Any commercial use of this product will void this limited warranty.

Drive belts, revolving brushes, disposable bags, and other parts subject to normal wear are not covered by this limited warranty.

This limited warranty does not apply to any part subjected to accident, abuse, commercial use, alteration, misuse, damage caused by fire or act of God, the use of voltages other than indicated on the serial number plate of this product or service of this product by other than ORECK or an ORECK Factory Authorized Service Center.

ORECK does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product.

ORECK’s limited warranty is valid only if you retain proof of purchase from ORECK or an ORECK Authorized Retail Dealer for this product. If you purchase this product from any other source, your purchase is “AS IS,” which means ORECK grants you no warranty, and that you, not ORECK, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.

ORECK’s liability for damages to you for any costs whatsoever arising out of this statement of limited warranty shall be limited to the amount paid for this product at the time of original purchase, and ORECK shall not be liable for any direct, indirect, conse- quential or incidental damages arising out of the use or inability to use this product.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

ALL EXPRESSED AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES, WHETHER EXPRESSED OR IMPLIED, WILL APPLY AFTER THIS PERIOD.

Some states do not allow limitations on the duration of implied warranties, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Troubleshooting Guide

WARNING: Unplug cord from electrical outlet before servicing.

SAVE SERVICE CALLS...CHECK THESE FIRST:

Is the disposable filter dust bag full?

Are pores of filter dust bag clogged with powder or fine dust?

Is anything clogging the hose, wands, power nozzle & accessories?

PROBLEM

POSSIBLE SOURCE

AREAS TO CHECK

CLEANER

Not plugged in

Be sure cleaner is

WILL NOT RUN

properly.

firmly plugged

 

 

into wall outlet.

 

No electricity in

Check electrical

 

wall outlet.

source–fuse or

 

 

circuit breaker.

 

Hose not

Connect hose.

 

connected to unit.

 

 

Switch on Power

Turn both

 

Handle or unit

switches on.

 

power pedal is off.

 

CLEANER

Filter bag is full.

Replace filter

DOES NOT PICK UP

 

 

bag. See “To

 

 

Install Filter Bag.”

 

Intake & Exhaust

Replace Filters.

 

Filters are

See “Replacing

 

blocked.

Intake Filter”, &

 

 

“Replacing

 

 

Exhaust Filter”.

 

Hose, Wand or

Clear obstruction.

 

Accessories are

 

 

clogged.

 

 

Suction Control

Close Suction

 

on Handle is

Control.

 

open.

 

POWER NOZZLE

Handle Switch is

Turn Handle

WILL NOT RUN

Off.

Switch On.

 

Brush in Power

If red indicator

 

Nozzle is

light illuminates,

 

clogged.

remove clog.

 

 

Press the red reset

 

 

button located on

 

 

back of power

 

 

nozzle.

 

 

 

ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER.

CALL CUSTOMER SERVICE HOT LINE

US: 1-800-989-3535

CANADA: 1-888-676-7325

Whenever calling, please be sure to have your model and serial number from data plate.

3

Image 3
Contents DTX 1400A DTX 1400B Table of Contents Maintenance Customer ServiceAccessories Sold Separately Troubleshooting Guide WarrantyDTX 1400A Assembly DTX 1400A Getting Ready for Use12B Lower Friction Wand Handle Park Management AdjustmentPower Nozzle Power nozzle until buttonOperating Instructions DTX 1400B Getting Ready for UseAdjustable for use on Replacing Filter BagStandard nozzle is Replacing Motor Filter Replacing Exhaust FilterStorage Comprend Entretien et service La clientèle Accessoires Vendus SéparémentTable des matières Guide de dépannage GarantieNomenclature du DTX 1400A Mise en œuvre du DTX 1400ABlockage de poignée 12B Mise en œuvre du DTX 1400B Nomenclature du DTX 1400BMode d’emploi Tapis sans brosse ou ’embout suceurStandard est réglable Pour utilisation surRangement Remplacement du filtre du moteur¡GUARDE Este Folleto Incluye Indice Mantenimiento y servicio ClientesAccesorios Vendido Por Separado Garantía Guía para identificación De problemasPreparación para la utilización de la DTX 1400A Ensamblaje de la DTX 1400AManguera y extraer Ensamblaje de la DTX 1400BPreparación para la utilización de la DTX 1400B Broche de la vara Boquilla motorizadaLa boquilla motorizada Instrucciones de operaciónLa posición l para la Unidad solamente o a laPesados Reemplazo de la bolsa de filtroReemplazo del filtro del motor Reemplazo del filtro del escapeAlmacenamiento