Oreck DTX warranty Replacing Filter Bag, Standard nozzle is, Adjustable for use on

Page 7

E N G L I S H

 

The standard nozzle is

 

adjustable for use on

 

carpets (without brush) or

CARPET

hard floors (with brush).

BARE FLOOR

Replacing Filter Bag

Check bag frequently or when bag full indicator has been activated.

Note: If picking up fine debris, change bag more frequently.

INDICATOR

LABEL

RESET BUTTON

To adjust suction, use the suction control on the handle.

To adjust power of motor, use the slide control on top of unit.

Upholstery tool, crevice tool and dusting brush can be found in storage compartment.

Small accessories can be used with telescopic wand, friction wands, or handle alone.

Note: Under proper operating conditions the green indicator light on the power nozzle will illuminate. If roller brush becomes stalled, the red indicator light will illuminate. Remove clog or source of stall, and press the red reset button on the back of the power nozzle to continue use.

BAG FULL

INDICATOR

Switch the unit off. Unplug unit from wall outlet. Open the cover by lifting the latch in front of the intake.

Remove dust bag by raising handle on bag carrier and lifting carrier out.

Remove the bag from carrier by pulling the cardboard tag. The Saniseal® dust seal will close automatically.

Insert a new bag into carrier by sliding cardboard into slots on carrier until bag is fully inserted. Bend rear part of dustbag downwards.

Replace the carrier into the unit.

Close the cover by pressing it down until it latches. The cover cannot be closed if a bag is not present or inserted properly.

7

Image 7
Contents DTX 1400A DTX 1400B Maintenance Customer Service Table of ContentsAccessories Sold Separately Troubleshooting Guide WarrantyDTX 1400A Getting Ready for Use DTX 1400A Assembly12B Lower Friction Wand Handle Park Management AdjustmentPower Nozzle Power nozzle until buttonOperating Instructions DTX 1400B Getting Ready for UseReplacing Filter Bag Adjustable for use onStandard nozzle is Replacing Exhaust Filter Replacing Motor FilterStorage Comprend Accessoires Vendus Séparément Entretien et service La clientèleTable des matières Guide de dépannage GarantieMise en œuvre du DTX 1400A Nomenclature du DTX 1400ABlockage de poignée 12B Mise en œuvre du DTX 1400B Nomenclature du DTX 1400BMode d’emploi Tapis sans brosse ou ’embout suceurStandard est réglable Pour utilisation surRangement Remplacement du filtre du moteur¡GUARDE Este Folleto Incluye Mantenimiento y servicio Clientes IndiceAccesorios Vendido Por Separado Garantía Guía para identificación De problemasPreparación para la utilización de la DTX 1400A Ensamblaje de la DTX 1400AManguera y extraer Ensamblaje de la DTX 1400BPreparación para la utilización de la DTX 1400B Broche de la vara Boquilla motorizadaLa boquilla motorizada Instrucciones de operaciónLa posición l para la Unidad solamente o a laPesados Reemplazo de la bolsa de filtroReemplazo del filtro del escape Reemplazo del filtro del motorAlmacenamiento