Assembly
To Replace Filter
Dust Bag
To assist you in assembling your cleaner, the parts have been numbered as follows:
1 Handle section, upper
2 Tube, lower
3Power head
4Outer bag
5 Paper filter dust bag 5
6Power cord
7Retaining spring
8Bag tension bar
9 Zip fastener
10 On/off switch
11Cord hook
12Plastic loop/cable clamp
13Connector assembly
14Fan housing
15Cord assembly
16Handle Brace
17Cord Strain Relief
10 
| 9 |
| 11 |
|
|
| |
|
| 12 | 1 |
|
|
| |
|
|
| 17 |
|
|
| 16 |
4 |
| 13 |
|
|
|
| |
|
| 2 | 6 |
|
|
| |
8 | 7 | 14 | 15 |
|
| ||
| 3 |
|
|
| WARNING: Unplug cord from |
| electrical outlet before servicing. |
| BAG INSTALLATION: |
| 1. Hook bottom of bag collar |
| opening under lip “B” of |
A | connector assembly. Pull up |
| on bag collar and snap over |
B | lip “A” of connector. |
| 2. Press on edges of bag collar |
| to insure bag is completely |
| installed. |
1
Connector |
|
Assembly |
|
2 | Upper |
| Handle |
| Brace |
Connector |
|
Assembly |
|
3 |
|
Before assembling appliance, remove two screws from connector assembly. Remove cardboard insert by pulling upward.
With On/Off switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Place brace against handle and connector assembly aligning screw holes. Insert short screw into top hole and long screw into bottom hole then tighten firmly until handle is no longer loose.
Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.
IMPORTANT: Check to make sure bag collar is behind lips “A” and “B”. If it is not, dust will leak into outer bag. When filter bag is in place, close outer bag with zipper fastener.
Using An Oreck
Fresh Air® Tab
Your ORECK XL vacuum cleaner has a special FRESH AIR tab pocket. This pocket is located inside the outer bag in the area where the disposable paper bag attaches to the intake tube. Insert tablet in pocket.
4