Heath Zenith 5213 manual Operation, Models 5212

Instant Motion Sensor Light Control

Models 5212 and 5213

Features

•Turns on lighting when motion is detected.

•Automatically turns lighting off.

•Photocell keeps the lighting off during daylight hours.

Requirements

•The Light Control requires a properly installed and working light fixture, operating on 120 volts AC.

•If you want to use Manual Mode, the fixture must be wired through a switch.

OPERATION

Mode:	On-Time:	Works: Day	Night
Test	5 Sec	x	x
Auto	1, 5, 10 min.		x
Manual	Until Dawn*		x

*resets to Auto Mode at dawn.

TEST

Put the ON-TIME switch on the bottom ON-TIMEof the sensor in the TEST position.

10 5 1 TEST

AUTO

Put the ON-TIME switch in the 1, 5	ON-TIME
or 10 minute position.
	10 5 1 TEST
MANUAL OVERRIDE

Parts

Package includes:

•Motion Sensor

•Lamp Adapter (5213)

•Two mounting screws

Typical Installation

The lamp module should only be used with Listed lamp fixtures. Never use a light bulb with a higher wattage rating than the rating of your fixture.

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

ManualmodeworkswiththeON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

Existing Light Fixture

Lamp Adapter

Sensor

Module

Sensor	Floodlamp
Cord
	(not included)

			... back on.
	Mode Switching Summary
	TEST	Move ON-TIME Switch
		to 1, 5 or 10 minutes
	AUTO		Flip switch off for
			one second then
MANUAL MODE			back on

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

© 2005 DESA Specialty Products™ 595-5734-04