Desa Tech CGN20TL, CGN30TL Operating Heater, For Your Safety Read Before Lighting

Page 17

OPERATING HEATER

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING

WARNING ICON

G 001

If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

Ignitor Button

Control Knob

PILOT

LO

OFF

 

HI

 

IGNITOR

Figure 16 - Control Knob In The OFF Position

Continued

103873

17

Image 17
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information ContentsIf you smell gas Safety Device Local Codes Unpacking Product FeaturesProduct Identification Piezo Ignition SystemProviding Adequate Ventilation Fresh AIR ForVentilation Determining if You Have a Confined or Unconfined Space Fresh AIRDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Fresh AIR for Combustion and VentilationVentilation AIR Ventilation Air from Outdoors Ventilation Air From OutdoorsInstallation Items Installing to WallCheck GAS Type Locating HeaterAttaching Thermostat Sensing Bulb Thermostat Sensing BulbLocating Thermostat Sensing Bulb Bracket Maintain minimum clearances shown in . If you can, provide Marking Screw LocationsGreater clearances from floor and joining wall Attaching Mounting Bracket To WallPlacing Heater On Mounting Bracket Installing Bottom Mounting ScrewsConnecting to GAS Supply To GAS ConnectingSupply Checking GASChecking Pressure Testing Heater GAS ConnectionsOperating Heater For Your Safety Read Before LightingOperating Heater Shutting Off Burner Only pilot stays lit Shutting Off HeaterPilot Flame Pattern Inspecting BurnerCorrect Burner Flame Pattern Burner Flame PatternCabinet Trouble ShootingODS/PILOT and Burner Trouble Cleaning and MainteTROUBLE- Shooting Ing and MaintenanceShut off gas supply If you smell gasDo not try to light any appliance Building20,000 Btu/Hr Models Technical ServiceService Hints Service Publications Parts Centrals Parts Under WarrantyCGN20T CGN20TL CGN30T CGN30TL Description QTY Parts ListValve GA5010 Accessories103873 Keep this Warranty Warranty Information