Fit over the burner see . Make sure the front

INSTALLATION

Installing Logs, Models CGS2718P, CGS2718N, CGS3124P and CGS3124N (Cont.) Installing Logs, Models CLD3018PA, CLD3018NA, CLD3924PTA and CLD3924NTA

INSTALLATION

Continued

2.Locate the notches on the back of the front log (#2). Slide these notches over the tabs of the grate base (see Figure 19).

3.Locate the notches in the bottom of the crossover log (#3). Place the crossover log on top of the back log and front log. Make sure the notches of the crossover log line up with rectangular knobs on top of the back and front logs (see Figure 20).

4.Add lava rock around base of heater if desired. Do not place lava rock on logs or burner.

Front Log (#2)

Notch

Tabs of

Grate Base

Figure 19 - Installing Front Log

INSTALLING LOGS, MODELS CLD3018PA, CLD3018NA, CLD3924PTA AND CLD3924NTA

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.	Place the base of the middle log (#1) in the U-shaped slots of
	the grate base. The cutout on the right of the middle log should
	fit over the burner (see Figure 21). Make sure the front of the
	middle log is resting on the tabs of the grate base and the cut-
	out area is centered over the burner “U” bend.
2.	Locate pegs on the bottom of back log (#2). Slide these pegs

Crossover Log (#3)

Notch

Rectangular Knob

	into the holes in the grate base behind the burner (see Figure 22,
	page 15).
3.	Locate the notches in the bottom of the front log (#3). Place the
	front log on the grate fingers. Make sure the notches of the front
	log line up with the grate fingers (see Figure 23, page 15).
4.	Place crossover log (#4) onto the pin (right) on back log (#2) and
	into the recess of the middle log (#1) (see Figure 24, page 15).
5.	Add lava rock around base of heater if desired. Do not place
	any lava rock on logs or burner.