Desa CGN10 installation manual Installing Two Mounting Screws, Folding Anchor

INSTALLING	Installing Two Mounting Screws
	Note: Wall anchors and mounting screws are in hardware package. The hardware
TO WALL
	package is provided with heater.
Continued Attaching to wall stud method
	For attaching mounting screw to wall stud
	1.	Drill hole at marked location using 9/64" drill bit.
	2.	Insert mounting screw into wall stud.
	3.	Tighten screw until 1/16" space (thickness of penny) is between screwhead and
		wall.

Attaching to wall anchor method

Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.

2.Fold wall anchor (see Figure 6).

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

Figure 6 - Folding Anchor

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings (see Figure 7). IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

5.Tighten two screws until 1/16" space (thickness of penny) is between screwheads and wall (see Figure 8).

Thin Walls

(1/4" to 1/2" thick)

Figure 7 - Popping Open Anchor Wings For Thin Walls

Thin or Thick Wall (thick wall shown)

1/16" Space

Solid Wall

ANCHOR

Figure 8 - Tightening Anchors

Continued

11

099404