Desa CGB3924NR AIR for Combustion Ventilation, Determining FRESH-AIR Flow for Heater Location

Page 5

OWNER’S MANUAL

AIR FOR

COMBUSTION AND

VENTILATION

Continued

DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION

Determining if You Have a Confined or Unconfined Space

Use this work sheet to determine if you have a confined or unconfined space.

Space: Includes the room in which you will install heater plus any adjoining rooms with doorless passageways or ventilation grills between the rooms.

1.Determine the volume of the space (length x width x height).

Length x Width x Height = _________________ cu. ft. (volume of space)

Example: Space size 20 ft. (length) x 16 ft. (width) x 8 ft. (ceiling height) = 2560 cu. ft. (volume of space)

If additional ventilation to adjoining room is supplied with grills or openings, add the volume of these rooms to the total volume of the space.

2.Divide the space volume by 50 cubic feet to determine the maximum Btu/Hr the space can support.

_________________ (volume of space) ÷ 50 cu. ft. = (Maximum Btu/Hr the space can support)

Example: 2560 cu. ft. (volume of space) ÷ 50 cu. ft. = 51.2 or 51,200 (maximum Btu/Hr the space can support)

3.Add the Btu/Hr of all fuel burning appliances in the space.

Vent-free heater

________________ Btu/Hr

 

 

 

 

Gas water heater*

________________ Btu/Hr

Example:

 

 

 

Gas furnace

________________ Btu/Hr

Gas water heater

 

40,000

Btu/Hr

Vented gas heater

________________ Btu/Hr

 

Vent-free heater

+

39,000

Btu/Hr

Gas fireplace logs

________________ Btu/Hr

Total

=

79,000

Btu/Hr

 

Other gas appliances* + ________________ Btu/Hr

 

 

 

 

Total

= ________________ Btu/Hr

 

 

 

 

*Do not include direct-vent gas appliances. Direct-vent draws combustion air from the outdoors and vents to the outdoors.

4.Compare the maximum Btu/Hr the space can support with the actual amount of Btu/Hr used.

_________________ Btu/Hr (maximum the space can support)

_________________ Btu/Hr (actual amount of Btu/Hr used)

Example: 51,200 Btu/Hr (maximum the space can support) 79,000 Btu/Hr (actual amount of Btu/Hr used)

The space in the above example is a confined space because the actual Btu/Hr used is more than the maximum Btu/Hr the space can support. You must provide additional fresh air. Your options are as follows:

A.Rework worksheet, adding the space of an adjoining room. If the extra space provides an unconfined space, remove door to adjoin- ing room or add ventilation grills between rooms. See Ventilation Air From Inside Building, page 6.

B.Vent room directly to the outdoors. See Ventilation Air From Outdoors, page 6.

C.Install a lower Btu/Hr heater, if lower Btu/Hr size makes room unconfined.

If the actual Btu/Hr used is less than the maximum Btu/Hr the space can support, the space is an unconfined space. You will need no additional fresh air ventilation.

WARNING: If the area in which the heater may be operated is smaller than that defined as an unconfined space or if the building is of unusually tight construction, provide adequate combustion and ventilation air by one of the methods described in the National Fuel Gas Code, ANSI Z223.1, 1992, Section 5.3 or applicable local codes.

Continued

104306

5

Image 5
Contents What to do if YOU Smell GAS Yellow Flame Model ShownSafety Information Product Identification Product FeaturesLocal Codes UnpackingProviding Adequate Ventilation AIR for Combustion and VentilationUnusually Tight Construction Confined Space and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Installation InstallationLOG Sizing Requirements Check GAS TypeMinimum Non-Combustible Material Clearances If Not Using MantelIf Using Mantel Floor Clearances Mantel ClearancesInstallation Items Needed Installing Heater Base AssemblyPressure Testing gas Supply Piping system Connecting to GAS SupplyChecking GAS Connections Test Pressures In Excess Of 1/2 PsigPressure Testing Heater Gas Connections Volt Battery InstallationInstalling 9-Volt Alkaline Battery In Receiver Installing 9-Volt Battery In Hand- Held Remote Control UnitPlace the base of the middle log #2 Installing Logs CGD3924NRInstalling Back Log #2 Installing Logs on Models CGB3924PR and CGB3930PRLighting Instructions For Your Safety Read Before LightingOperating Heater To Turn OFF GAS To Appliance Manual Lighting ProcedureThermostat Control Operation Hand Held Remote OperationInspecting Burners Cleaning and MaintenanceObserved Problem Possible Cause Remedy TroubleshootingMaintenance, Gas leak. See Warning statement at TopWiring Diagram SpecificationsaccessoriesTechnical Service Service HintsCGD3924NR Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListCGB3924NR CGB3930NR KEY CGB3924NR CGB3930NR Part Number Description QTY Parts Under Warranty Replacement PartsParts not Under Warranty Parts Central104306 Warranty Information