14
INSTALLING HEATER
Continued
INSTALLING GLASS PANEL
1. Locate the glass panel package inside the back of the heater.
CAUTION
Before installing glass panels, inspect the edges. If you notice any chips or cracks, do not install. If the surface on either side is deeply scratched, do not install. If these conditions exist, contact your Vanguard dealer for replacement glass panels.
CAUTION
Do not operate heater without glass panels installed. Operating heater without glass panels will damage front of heater due to excess temperatures.
CAUTION
Glass panels may have sharp edges. Handle with care.
2.Remove lower front access panel of heater by removing two screws at upper corners of panel. The lower front access panel covers the lower front access area (see Figure 9).
3.Remove two screws on glass guard. Remove glass guard (see Figure 9).
4.Carefully insert one glass panel up through lower front access area (see Figure 10, page 15).
5.Carefully slip glass panel behind hearth assembly (see Figure 10, page 15).
Glass
Guard
Lower Front
Access Panel
Figure 9 - Removing Lower Front Access Panel
100353