Remington REM10PT installation manual OWNER’S Operation Installation Manual

Page 1

BLUE FLAME VENT-FREE

PROPANE/LP GAS HEATER

®

OWNER’S OPERATION AND

INSTALLATION MANUAL

For..com

REM10PT

10,000 Btu/Hr

Thermostatically-

Controlled Heater

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result caus- ing property damage, personal injury, or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s in- structions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For as- sistance or additional information consult a qualified installer, ser- vice agency, or the gas supplier.

WARNING: This is an unvented gas-fired heater. It uses air (oxy- gen) from the room in which it is installed. Provisions for ad- equate combustion and ventila- tion air must be provided. Refer to Air for Combustion and Venti- lation section on page 4 of this manual.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

Save thisfor future.

Image 1
Contents REM10PT OWNER’S Operation Installation ManualWhat to do if YOU Smell GAS Safety Information Table of ContentsUnpacking Product IdentificationInstallation Product FeaturesLocal Codes PROPANE/LP SupplyThermostat Sensing Bulb Installing Heater to WallInstalling Bottom Mounting Screw Connecting to Portable Cylinder GAS SupplyInstallation Items Connecting to Permanent GAS SupplyPermanent GAS Supply Pressure Testing Gas Supply Piping SystemPressure Testing Heater Gas Connections For Your Safety Read Before LightingOperating Heater Checking GAS Connections for Permanent GAS SupplyTo Turn OFF GAS To Appliance Manual Lighting ProcedureThermostat Control Operation Shutting Off HeaterStorage Inspecting BurnerPilot Flame Pattern Burner Flame PatternCleaning Burner Pilot AIR Inlet Cleaning MaintenanceODS/PILOT and Burner CabinetObserved Problem Possible Cause Remedy TroubleshootingMaintenance, Gas leak. See Warning statement at REM10PT Pilot Illustrated Parts BreakdownREM10PT Parts ListTechnical Service SpecificationsService Hints Service Publications AccessoriesOwners Registration Form Postage Required 110373-01B Warranty Information