Quadra-Fire QV26E-B owner manual Getting Started, Tools and Supplies Needed

Page 5

2Getting Started

A. Design and Installation Considerations

C. Inspect Heater and Components

CAUTION

Check building codes prior to installation.

•Installation MUST comply with local, regional, state and national codes and regulations.

•Consult insurance carrier, local building inspector, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.

When planning a heater installation, it is necessary to deter- mine the following information before installing:

•Where the heater is to be installed. See Sections 3 and 4.

•Electrical wiring. See Section 4.

•Framing and fi nishing details. See Sections 3 and 6.

•Whether optional accessories—devices such as a fan, wall switch or remote control—are desired. See Section 10.

B. Tools and Supplies Needed

Before beginning the installation be sure the following tools and building supplies are available:

Reciprocating saw

Framing material

Pliers

Wall-fi nishing materials

Hammer

Gloves

Phillips screwdriver

Framing square

Flat blade screwdriver

Electric drill and bits

Plumb line

Safety glasses

Level

Tape measure

Surround

 

1/2-3/4 in. length, #6 or #8 self-drilling screws Misc. screws and nails

CAUTION

Sharp Edges

•Wear protective gloves and safety glasses during installation.

WARNING

Fire Risk

Inspect heater and components for damage.

Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

•Do NOT install substitute components Report damaged parts to dealer.

•Carefully remove the heater and components from the packaging.

•Report to your dealer any parts damaged in shipment.

•Read all the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.

CAUTION

•Keep heater dry.

•Mold or rust may cause odors.

Note: Minimum and maximum clearances must be maintained at all times. Illustrations throughout these instructions refl ect typical installations and are for design purposes only. Actual installation may vary slightly due to individual design preferences.

The illustrations and diagrams used throughout these installation instructions are not drawn to scale.

Quadra-Fire • QV26E-B • 4038-897 Rev C • 11/05

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents QV26E-B Listing Label Information/Location Homeowner Reference InformationTable of Contents Fire Risk Important InstructionsNot intended for use as a primary heat source Tools and Supplies Needed Getting StartedSelecting Heater Location Framing and ClearancesClearances Electrocution RiskHeater Locations Model #Framing the Heater Frame the HeaterAs a Fireplace InstallationShock Risk Shock Risk Fire RiskAs an Insert Pre-installation PreparationWiring Orange 3 PIN Install other Optional Accessories AccessoriesInstall the Front Face Finishing Finishing ChecklistFinishing Material MantelThermostat Main Power SwitchOperating Instructions Troubleshooting Guide TroubleshootingAccess the Firebox Maintenance and ServiceClean the Firebox Compartment Clean the Back Acrylic PanelWhen cleaning glass door Maintenance Task ListReference Materials Heater DimensionsSST = Stainless Steel Trim Optional ComponentsPBT = Polished Brass Trim Model Description Width Height FrontsQV26E-B Service Parts23/26 Log Assembly Hearth AssemblyThermostat Control Assembly # Description of PartThis page intentionally left blank How to Obtain Service Limited WarrantyHearth & Home Technologies Inc North Highway Colville, WA Contact Information
Top Page Image Contents