3Framing and Clearances
| WARNING |
| Note: |
Fire Risk |
| • Illustrations and photos refl ect typical installations | |
Provide adequate clearances. |
| and are FOR DESIGN PURPOSES ONLY. | |
| • Illustrations/diagrams are not drawn to scale. | ||
• | Around air openings |
| |
• | To combustibles |
| • Actual installation/appearance may vary due to |
• | For service access. |
| individual design preference. |
| • Hearth & Home Technologies reserves the right to | ||
Locate heater away from traffic areas. |
| ||
| alter its products. | ||
|
|
| |
|
|
|
|
A. Selecting Heater Location
Several options are available to you when choosing a loca- tion for your heater. This heater may be used as a room divider, installed along a wall, across a corner or used in an exterior chase. See Figure 3.1. This heater may be installed directly on the fl oor, carpet or raised on a hearth.
DANGER
Electrocution Risk
•NEVER locate this heater where it may fall into a bathtub or other water container.
B. Clearances
Figure 3.1 shows all clearances that must be maintained around the heater.
WARNING
Fire Risk
Due to high temperature, this heater should be located out of high traffic areas.
•Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 12 in. (305 mm) from the front of the heater.
WARNING
Fire Risk!
•Prevent contact with sagging, loose insulation.
•Do NOT install against vapor barriers or exposed insulation.
WARNING
Do NOT use this heater if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system which has been under water.
6 |