Samsung RF26NBBP1/SML, RF26NBUS2/SML, RF26NESH1/SML manual Adjusting ThE Freezer Drawer lEVEl

1.If you open the drawer ( 1 ), you can see the lower hinge ( 2 ).

2.Insert the supplied hex wrench ( 3 ) into the shaft ( 4 ) of the lower hinge.

3.Please adjust the height turning the hex wrench ( 3 ) clockwise( ) or

counter-clockwise ( ).

2
3	3
4

1

When you turn the hex wrench counter-clockwise( ), the door will move up.

4.After adjusting the doors, please insert the supplied fastener-ring ( 5 ) using a pair of pliers ( 6 ) in the gap between the hinge-grommet ( 7 ) and the lower hinge( 8 ). The number of fastener-rings you’ll need to insert depends on the gap.

Two fastener-rings are enclosed with the refrigerator.

The thickness of each fastener-ring is 1mm(0.04 inch).

ADJUSTING ThE FREEZER DRAWER lEVEl

Adjustment part

Freezer Drawer

1.Locate the height-adjuster ( 1 ) in the freezer drawer.

Unscrew the four Phillips screws ( 2 ) slightly to loosen the door.

2.Loosen the controller screw( 3 ) with a Phillips screwdriver.

3

1 2

01 SETTING UP

Setting Up _13