Samsung RF26NBRS1/SML, RF26NBUS2/SML, RF26NBBP1/SML manual DISASSEMblE ThE Refrigerator Doors

DISASSEMblE ThE REFRIGERATOR DOORS

1. With the door opened, remove the Top Table cap ( 1 ) with a Flat head screwdriver, and close the door. Remove the 3 screws holding down the Top Table and remove the Top Table( 2 ).

2

1

01 SETTING

2.Disconnect the electrical connector

( 3 ) above the upper right door hinge and the 3

electrical connectors ( 4 ) above the	4
upper left door hinge.
Disconnect the water tube ( 5 ) by
pulling the tube fitting ( 6 ) apart as
shown in the picture.
	Red Clip
	(1/4”)

3

5 6

UP

3. Remove the 3 hex head bolts( 7 ) found attached
to the upper left and right door hinges with a	8
Wrench(10mm).	7
With a Philips head screwdriver, remove the
ground screw( 8 ) found attached to the upper	9
left and right door hinges. Remove the upper left
and right door hinges( 9 ).

4.Lift the door straight up to remove.

5.With a Philips head screwdriver, remove the 2 screws (10) attached to the lower left and right door hinges.

With a Allen wrench(5mm), remove the 2 hex	12
head bolts (11) attached to the lower left and right	10
door hinges.	11
Remove the lower left and right door hinges(12).

• Be careful not to missplace the hinge cap because it can be easily taken off.

Setting Up _9