INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply &
ICE
2) Run water through the dispenser about the first six glassfuls of water. This will clean the water supply system and clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around the water filter.
WATER
• A
Check the amount of water supplied to the ice tray.
1) Lift up (①) and pull out (➁) the ice maker bucket in the freezer.
2)When you press the test button, the ice cube container is filled with water from the water supply tap.
Check the amount of water (see the illustration If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact
a service person to check the amount of water supplied.
ICE MAKER
TEST BUTTON
TOO HIGH
OPTIMUM
LEVEL
TOO LOW
30