NEC TheaterSync Video Processor user manual Installation, List of Standard Components

Page 14

MKT-0026-UMN-1.002F

TheaterSync Video Processor User Manual

3 Installation

3.1List of Standard Components

The TheaterSync processor ships with a number of standard components. When unpacking your unit, verify that the following items are included:

•TheaterSync unit (qty 1)

•IEC-320 American AC power cord (qty 1)

•Infrared remote control (qty 1)

•Rack-mount adapter kit (qty 1)

•TheaterSync User Manual (qty 1)

3.2Setting up your TheaterSync

To set up your TheaterSync unit, follow the steps below:

1.Connect the TheaterSync unit to the video input sources.

2.Connect the TheaterSync unit to the display device.

NOTE: If you are connecting to a panel or projector that supports the coding of HDCP encrypted material on its DVI input, you must connect to that DVI input using TheaterSync’s HDMI OUT connector (and an HDMI to DVI adapter).

3.To power up the unit, press the Power switch located on the rear of the unit, close to the power cord. The Power switch may be left on in normal operation. The On/Setup button on the front panel may be used to put the unit into a low-power state (Setup Mode).

NOTE: When TheaterSync is in Setup (Stand-by) Mode, the output to the projector or panel is temporarily suspended.

4.Select the output resolution to match the native resolution of the display device:

a)Place the unit in Setup (Stand-by) Mode by toggling the Operate/Setup button on the IR remote (or by using the On/Setup button on the unit’s front panel).

b)Using the up/down arrow keys of the remote, cycle through the different setup modes (which will be displayed on the box LCD display) until the output resolution mode is selected (“OUT = xxx” will appear on the LCD display, where ‘xxx’ is the current active output resolution)

c)Using the left/right arrow keys, select the desired output resolution.

5.Return TheaterSync to Operate Mode by pushing the On/Setup button on the front panel or the Power button on the IR Remote. This activates the TheaterSync output circuits. Further adjustments may be made using the TheaterSync OSM (On-Screen Menu).

Page 14

NEC Solutions, Inc.

Page 13 Page 15
Image 14
Page 13 Page 15
Contents NEC TheaterSync Video Processor Copyright and Trademark Information Table of Contents Limited Warranty PrefaceWhat WE will PAY for and What WE will not PAY for 1250 N. Arlington Heights Road, Suite Itasca, Illinois Related Documents FCC StatementTelephone Safety Important Safety InstructionsMaintenance MKT-0026-UMN-1.002F Introduction General DescriptionTypical TheaterSync Application Features and Specifications Panel Diagrams List of Standard Components InstallationSetting up your TheaterSync MKT-0026-UMN-1.002F IR Remote Control TheaterSync User InterfaceTheaterSync Operational Modes Operate Mode Setup Parameters Parameter Description1Output Mode Comments TheaterSync Output ModesMKT-0026-UMN-1.002F OSM Main Menu Structure On-Screen MenuOSM Menu Structure OSM Complete Menu Structure OSM Menu Level CommentsSharpness Sharper the image edge Enhancement 180 100 Default Off default Fpga BCE Aspect Ratio MKT-0026-UMN-1.002F Aspect Ratio Treatments for 43 Input with 43 Output Aspect Ratio Treatments for 43 Input with 169 OutputMKT-0026-UMN-1.002F Aspect Ratio Treatments for 169 Input with 43 Output Aspect Ratio Treatments for 169 Input with 169 Output Appendix a Input Modes SupportedYES SXGA+ MKT-0026-UMN-1.002F NEC Solutions, Inc
Top Page Image Contents