TheaterSync Video Processor User Manual |
|
parameters, such as Output Resolution. Visual feedback for the adjustments of Setup Mode is seen on the 24 x 2 LCD display, rather than on OSM of the main screen. Sensitive parameters are placed in the Setup Menu so that an inadvertent key stroke with the IR remote does not cause a change in a parameter that would be difficult to recover from. Table 1 lists the Setup parameters and Table 2 lists the output resolutions currently supported in the unit.
| Table 1: Setup Parameters | ||
|
|
| |
Parameter |
| Description1 | |
OUT = XXX ## Hz |
| Cycles through all of the available TheaterSync output | |
| modes (see Table 2 for a list of Output Resolutions). | ||
|
| ||
LCD Brightness = On (Off) |
| Turns On (Off) the 24 x 2 LCD Display during Operate | |
| Mode | ||
|
| ||
|
| These settings enables to adjust the output sync: | |
|
| Free Run – Establishes a precise output timeline | |
Output Sync = Free Run (Vadjust 1:1, | Vadjust 1:1 – Forces the output timeline to be frame | ||
locked to the input by inserting or deleting entire lines of | |||
Vjam) |
| ||
| output video | ||
|
| ||
|
| Vjam – Maintains frame lock by truncating final line of | |
|
| output frame | |
BAUD = ##### |
| Lets you choose a baud rate of 1200, 9600, 19200, | |
| 57600, or 115000. | ||
|
| ||
OSM Location = Input (Output) |
| The OSM may be located pre (Input side) or post (Output | |
| side) scaling and keystone correction | ||
|
| ||
PC Control = Active (Inactive) |
| Turns On (Off) the computer control capability | |
|
|
| |
DHCP = On (Off) |
| Turns on Dynamic IP Address Selection | |
IP=aaa.bbb.ccc.ddd |
| Select IP Address (selectable only if DHCP = Off) | |
|
|
| |
DNS=aaa.bbb.ccc.ddd |
| Select DNS Address (selectable only if DHCP = Off) | |
|
|
| |
2nd DNS=aaa.bbb.ccc.ddd |
| Select Alternate DNS Address | |
|
| (selectable only if DHCP = Off) | |
Gateway=aaa.bbb.ccc.ddd |
| Select Gateway Address (selectable only if DHCP = Off) | |
|
|
| |
SubMask=aaa.bbb.ccc.ddd |
| Select SubNet Mask (selectable only if DHCP = Off) | |
|
|
| |
Serial No = ###### |
| Indicates the Serial # of TheaterSync unit | |
|
|
| |
MAC = ## ## ## ## ## ## |
| Indicates the MAC Address of TheaterSync unit | |
|
|
| |
1The default parameters configurations are highlighted in bold.
NEC Solutions, Inc. | Page 19 |