| Table 2: TheaterSync Output Modes | |
|
|
|
Output Mode |
| Comments |
VGA 60 Hz (640 x 480) |
| VESA Standard |
VGA 50 Hz (640 x 480) |
| VESA Standard |
848 x 480 60 Hz |
| / |
SVGA 60 Hz (800 x 600) |
| VESA Standard |
SVGA 50 Hz (800 x 600) |
| VESA Standard |
720p 60 Hz (1280 x 720) |
| SMPTE Standard |
720p 50 Hz (1280 x 720) |
| SMPTE Standard |
XGA 72 Hz (1024 x 768) |
| VESA Standard |
XGA 60 Hz (1024 x 768) |
| VESA Standard |
XGA 50 Hz (1024 x 768) |
| VESA Standard |
1360 x 768 60 Hz |
| / |
1365 x 768 60 Hz |
| / |
1400 x 788 60 Hz |
| / |
SXGA 60 Hz (1280 x 1024) |
| VESA Standard |
SXGA 50 Hz (1280 x 1024) |
| VESA Standard |
SXGA+ 60 Hz (1400 x 1050) |
| VESA Standard |
SXGA+ 50 Hz (1400 x 1050) |
| VESA Standard |
1080p 60 Hz (1920 x 1080) |
| SMPTE Standard |
1080p 50 Hz (1920 x 1080) |
| SMPTE Standard |
1080p 48 Hz (1920 x 1080) |
| SMPTE Standard |
QXGA 60 Hz (2048 x 1536) |
| / |
QXGA 50 Hz (2048 x 1536) |
| / |
QXGA 48 Hz (2048 x 1536) |
| / |
On entry to setup mode, the 24 x 2 LCD display indicates the following:
THEATERSYNC
Setup
Select the Menu key on your IR Remote to bring up the Setup Menu on the 24 x 2 LCD display. The LCD display will indicate the following:
“Parameter” = ???
Setup Mode
Using the Up and Down navigation keys on the remote, you can select the next parameter in a circular list of parameters. Using the Left and Right navigation keys on the remote, you can select the value of the parameter. In some cases, the parameter is visible in the setup menu, but may not be altered (such as Serial Number or MAC Address).
Selection of IP addresses is slightly different. IP addresses may only be selected if the DHCP parameter has been set to “Off”. In this case, you use the Left or Right navigation key to “enter” the IP address. The Left key will highlight the rightmost octet; the Right key will select the
Page 20 | NEC Solutions, Inc. |