23
NPI40 FINISHING
FLASHING INSTALLATION
7. Slide the assembled |
|
trim down over the | FIGURE 31 |
1.Secure the
Right Flashing |
|
to the right |
|
side of the |
|
unit using two |
|
of the #8 x |
|
1/2" screws. |
|
NOTE: Feed |
|
the Air |
|
Control Rod |
|
into the Air |
|
Control Slot |
|
on the Right |
|
Flashing |
|
before securing. | AIR |
(FIGURE 26) | |
| CONTROL |
| ROD |
| AIR |
| CONTROL |
| SLOT |
FIGURE 26
CONTROL
PANEL
RIGHT
FLASHING
L |
|
O | 1 |
W |
2
3
4 | H |
5 | |
| IG |
| H |
BURN
RATE LABEL
flashing. (FIGURE 31)
8. Affi x the logo to the bottom left hand corner
of the left fl ashing.
TRIM
ASSEMBLY
TRIVET NPI40
The trivet for the NPI40 is attached by two set screws on the inside of the hopper lid.
2.Twist spring handle (supplied with the heater) onto the air control rod until it hits the stop.
3.Remove the two control panel securing screws, discard the screws and shipping bracket. (FIGURE 27)
4.Secure the control panel to the Right Flashing using the two #8 x 3/8" screws. (FIGURE
20) Secure the Left Flashing with the remaining #8 x 1/2" screws. (FIGURE 26)
3 | 2 | 2 | 3 |
4 | 1 | 1 | 4 |
5 |
|
| 5 |
SHIPPINGCONTROL
BRACKETPANEL
SECURINGSECURING SCREWS FIGURE 27 SCREWS
FIGURE 28
Figure 32
INSTALL VIEWING DOOR NPS40 AND NPI40
The main viewing door has been boxed separate from the heater, but MUST be installed
before burning the heater.
5.Align the holes
in the top of the Right and Left Flashing with those on the bottom lip of the Top Flashing and secure from the rear using the four
6.The three
pieces of trim are |
| |
assembled in the |
| |
same manner as |
| |
a picture frame. Place the corner |
| |
brackets (with screw loosened) |
| |
into the trim sections. Tighten the |
| |
screw spreading the two pieces |
| |
apart. Attach the adjoining section. |
| |
Repeat with the opposite side. | FIGURE 30 | |
Tighten all screws fi rmly. | ||
| ||
(FIGURE 30) |
|
FIGURE 29
TOP
FLASHING
Figure 33
(Insert
Illustrated)
1.Open both side panels, exposing the bushing on the left and the latches on the right.
2.Align the pins on the door to the bushing on the left side of the heater. Lower into place until both bushings touch.
3.Engage the latch hooks into the door frame. Snap the rear
handle hook to lock the latch closed. |
|