Napoleon Fireplaces manual General Maintenance NPS40 and NPI40, Open Main Viewing Door

Page 25
W415-0616 / B / 02.18.08

25

GENERAL MAINTENANCE NPS40 AND NPI40

DAILY (WHENEVER USING THE HEATER)

OPEN MAIN VIEWING DOOR

!WARNING

The front of the heater becomes very hot during opera- tion. Let the heater cool completely before conducting service.

1.Open the side doors on either side of the heater.

Figure 35

2.On the right side of the heater are two latches. Release the latches by pulling the rear handle forward and dis- engaging the hook from the door frame. Swing open the viewing door.

INSPECT THE BURN POT

When burning, the fl ames should be bright orange with embers jumping from the burn pot.

Figure 37

CLEANING GLASS DOOR

If the glass is not kept clean, permanent discolouration and/or blemishes may result. If glass should ever crack, it must be replaced using 5mm thick ceramic glass available from your Napo- leon Dealer.

DO NOT SUBSTITUTE MATERIALS

DO NOT CLEAN GLASS WHEN HOT

DO NOT use abrasive cleaners to clean glass or plated parts.

DO NOT OPERATE THIS HEATER WITH THE GLASS DOOR OPEN

CLEANING THE HEAT EXCHANGE TUBES

Figure 36

DISPOSAL OF ASHES

Ashes should be placed in a metal container with a tight fi tting lid. The container should be placed on a non-combustible fl oor, well away from combustible materials, pending fi nal disposal. If ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are thoroughly cooled.

!WARNING

The front edge of the hopper lid becomes very hot, do not touch the area below the handle.

Figure 40

!WARNING

This rod becomes very hot during operation. Wait till heat- er has cooled completely or you MUST wear heat resistant gloves when cleaning or handling this heater.

With the heater cool (or wearing heat resistant gloves), slide the heat exchange cleaner rod up and down several times to prevent the build up of ash on the heat exchange tubes.

Keep the viewing door closed so the fl y ash does not enter the room.

NOTE: More frequent cleaning may be required depending upon pellet quality.

Image 25
Contents W415-0616 / B $10.00 Table of Contents Napoleon Pellet Heaters Presidents Lifetime Limited Warranty W415-0616 / B W415-0616 / B Heating Specifications SpecificationsGeneral Introduction General InstructionsFigures 1a-b DimensionsFigures 3a-c Figures 4a-c General Installation Outside AIR Safety FeaturesMobile Home General Venting Installing the Pellet VentType of Vent Venting the Pellet HeaterI B F Minimum Clearance to Combustibles Straight Installation NPS40 InstallationCorner Installation Venting Installation Examples Class a Chimney Retrofit Minimum Inside Vertical ClearancesNPI40 Installation Installation Into a BUILT-IN Enclosure NPI40 Installation OverviewVertical Liner Installation Installation Into a Masonry Fireplace Prior to InstallationInstallation Into a Masonry Fireplace Liner Installation W415-0616 / B Minimum Enclosure Clearances Install Viewing Door NPS40 and NPI40 Flashing InstallationNPI40 Finishing Trivet NPI40SHUT-DOWN Operating InstructionsSTART-UP Lighting Heater ManuallyCleaning Glass Door General Maintenance NPS40 and NPI40Cleaning the Heat Exchange Tubes Disposal of Ashes Open Main Viewing DoorMake Sure Pellets are not Piling UP Cleaning the Burn POTVacuum Firebox Clean Exhaust Housing Insert only Clean the Vertical Exhaust DuctVacuum Hopper Soot and FLY ASH FormationClean the Vent Clean the Exhaust BlowerCheck ALL Seals Normal Operating Sounds Wiring Diagram Replacements Common Replacements Parts NPS40 Replacements Parts NPI40 Replacements Parts NPI40 Accessory Parts Symptom Test Solution TroubleshootingHeater will General Has tripped Heater will Service Date Service Technician Service Description Service and Maintenance LOGOwnership Records W415-0616 / B
Related manuals
Manual 44 pages 1.92 Kb