Monessen Hearth DFS42PVC, DFS36NVC, DFS42NVC, DFS32NVC, DFS32PVC ﬁreplace must be installed giving

Page 16

FIREPLACE FRAMING

When finishing a custom cabinet, mantel, or other built-in enclosure, the opening size to accommodate the fireplace with trim installed is as follows:

DFS32NVC DFS36NVC DFS42NVC

DFS32PVC DFS36PVC DFS42PVC

K 37⅞"41⅞"47⅞"

J 35⅞"35⅞"35⅞"


WARNING	WARNING
	The ﬁreplace must be installed giving
	full consideration to the clearance and
	height requirements identiﬁed in this
	manual.

K

J

Figure 13 - Custom Cabinet

1.Bend out the nailing flanges located on each side of the firebox.

2.Slide the firebox into prepared framing or position firebox in its final position and frame later.

3.Level the firebox by checking the top edge of the firebox. Shim if necessary.

4.Anchor firebox to the side framing members using 8d nails or other suitable fasteners. Refer to Figure 14.

5.The canopy must be installed for safe operation of the heater. Refer to page 12 for canopy installation details.

Nail Sides

Through Nailing

Flanges

Figure 14 - Location of Nailing Flanges

16

71D0532

Image 16

Contents What to do if YOU Smell GAS Read and Save These InstructionsContents Installer Important Safety InformationOwner From Product Features OperationNatural GAS PROPANE/LPGSpecifications Getting Started What YOU will Need for InstallationMake Sure YOU have Received ALL Parts General Installation Information Firebox Dimensions with Screen and Log SetsCodes Adequate Combustion and Ventilation AIRBTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Installing Canopy Removing ScreenDo not Install this Model in a Bedroom or Bathroom Location of FireplaceClearances and Height Requirements 21/2 16 1921Fireplace Framing Framing surfaceﬁreplace must be installed giving Connecting the GAS Flexible Tube Manual Shutoff Gas Supply Inlet ValveChecking GAS Pressure MILLI-VOLT Control FigureConnecting Optional Wall Switch Electrical WiringOperate Checking System Operation Connecting Remote ReceiverComplete MILLI-VOLT System Check LOG Placement Installing Charred Timber Logs on BurnerInstalling Left Base Log #3 Installing Left Top Log #5 Installing Right Top Log #6 Placing Rock WoolChecking the Pilot Flame Flame AppearanceMILLI-VOLT Control Checking the Burner Flame Correct Appearance of Rear Flames of Charred TimberOperating Instructions For Your Safety Read Before Lighting MILLI-VOLT Control Lighting Instructions Operating InstructionsOperating Instructions and Cleaning and Servicing Cleaning and ServicingBlower and Other Optional Equipment Optional EquipmentForced AIR KIT Optional TrimIllustrated Parts Breakdown Charred Timber LogsIllustrated Parts Breakdown Burner Assembly Replacement Parts ListAccessories Sold Separately Illustrated Parts Breakdown BRC36 BRC42 Troubleshooting Observed Problem Possible Cause RemedyODS/pilot lights, but flame Trim Installation Trim Installation For USE of Optional AK-4 Outside AIR KIT Combustion AIRModel AK-4 Combustion AIR Assembly Insulation Ring to Left Side of FireplaceInstalling Model 403 Duct Connector 71D0532 Five Year Warranty Basic Warranty