Monessen Hearth DFS42NVC, DFS36NVC, DFS32NVC, DFS32PVC, DFS42PVC, DFS36PVC manual Specifications

Page 7

SPECIFICATIONS

IGNITION CONTROLS

Piezo ignitor allows ignition of the pilot without the use of matches or batteries.

Milli-Volt control has four (4) positions:

OFF

- All gas to the gas logs is shut off at the valve.

IGN

- Valve position to light/maintain a standing pilot.

ON

- Valve position to turn ON/OFF log set with remote switch/thermostat.

LOW/HI

- Variable position to control flame height (heat output). Both front and rear burners are in operation

 

to provide realistic glow and yellow flame.

PILOT

 

The gas log heater is fitted with a specially designed safety pilot light (ODS assembly) which senses the amount of oxygen available in the room and shuts the gas log heater off if the oxygen level begins to drop below a satisfactory level. The pilot can only be relit when adequate fresh air is available.

THERMAL GENERATOR

The milli-volt gas log pilot is fitted with a milli-volt generator to provide power for remote activation.

71D0532

7

Image 7
Contents Read and Save These Instructions What to do if YOU Smell GASContents Installer Important Safety InformationOwner From Operation Product FeaturesPROPANE/LPG Natural GASSpecifications Getting Started What YOU will Need for InstallationMake Sure YOU have Received ALL Parts Firebox Dimensions with Screen and Log Sets General Installation InformationAdequate Combustion and Ventilation AIR CodesBTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Removing Screen Installing CanopyLocation of Fireplace Do not Install this Model in a Bedroom or Bathroom21/2 16 1921 Clearances and Height RequirementsFraming surface Fireplace Framingfireplace must be installed giving Flexible Tube Manual Shutoff Gas Supply Inlet Valve Connecting the GASMILLI-VOLT Control Figure Checking GAS PressureConnecting Optional Wall Switch Electrical WiringOperate Checking System Operation Connecting Remote ReceiverComplete MILLI-VOLT System Check Installing Charred Timber Logs on Burner LOG PlacementInstalling Left Base Log #3 Installing Left Top Log #5 Placing Rock Wool Installing Right Top Log #6Checking the Pilot Flame Flame AppearanceMILLI-VOLT Control Correct Appearance of Rear Flames of Charred Timber Checking the Burner FlameOperating Instructions For Your Safety Read Before Lighting Operating Instructions MILLI-VOLT Control Lighting InstructionsCleaning and Servicing Operating Instructions and Cleaning and ServicingOptional Trim Blower and Other Optional EquipmentOptional Equipment Forced AIR KITCharred Timber Logs Illustrated Parts BreakdownIllustrated Parts Breakdown Burner Assembly Replacement Parts ListAccessories Sold Separately Illustrated Parts Breakdown BRC36 BRC42 Observed Problem Possible Cause Remedy TroubleshootingODS/pilot lights, but flame Trim Installation Trim Installation Combustion AIR For USE of Optional AK-4 Outside AIR KITInsulation Ring to Left Side of Fireplace Model AK-4 Combustion AIR AssemblyInstalling Model 403 Duct Connector 71D0532 Basic Warranty Five Year Warranty