Monessen Hearth CFX24, CFX32 manual Match Lighting Instructions, Cleaning and Servicing

Page 26

CFX Vent Free Fireplace System

OPERATING INSTRUCTIONS

MATCH LIGHTING INSTRUCTIONS

1.Remove any items necessary for easy access to the pilot (for example: logs, screens, etc.).

2.Follow appropriate lighting instructions found previously. Instead of pushing and releasing the piezo button, light a match and hold the flame to the end of the pilot and ignite the pilot.

3.After control knob has been released and pilot stays lit, reinstall any items that were removed for pilot access.

4.Call a qualified service technician for repair or replacement of the piezo ignitor.

CLEANING AND SERVICING

Annual inspection and cleaning by your dealer or qualified service technician is recommended to prevent malfunction and/or sooting.

WARNING

Turn off heater and allow to cool before cleaning. Disconnect electrical power before cleaning or servicing.

Remove fireplace screen. Carefully lower screen from mounting lugs and set aside during clean- ing. See instruction manual for installation of screen. DO NOT OPERATE THE UNIT WITH THE

SCREEN REMOVED.

Remove logs, handling carefully by holding gently at each end. Gloves are recommended to prevent skin irritation from ceramic fibers. If skin becomes irritated, wash gently with soap and water. See manual for correct log placement.

Periodic Cleaning - See parts diagram for location of items discussed below.

Do not use cleaning fluid to clean logs or any part of heater.

Brush logs with soft bristle brush or vacuum with brush attachment.

Vacuum loose particles and dust from the front and rear burner, control and piezo covers and grate weldment.

Inspect and clean burner. Remove lint or particles with vacuum, brush or pipe cleaners.

External case should be dusted and wiped with a wet soapy cloth.

Annual Cleaning/Inspection - Refer to the parts diagram for location of items discussed below.

Inspect and clean all burner ports.

Inspect ODS pilot for operation and accumulation of lint at air intake holes.

Verify flame pattern and log placement for proper operation.

Verify smooth and responsive ignition of burner.

26

20301726

Image 26
Contents Vent-free Fireplace Systems Models CFX24, CFX32 What to do if YOU Smell GASContents CFX Vent Free Fireplace SystemOwner Important Safety InformationInstaller Important Safety Information CodesOperation Product Features & specificationsGas Specifications GAS pressuresFireplace & System Dimensions CFX24 CFX32Getting Started Handle with careAdequate Combustion and Ventilation AIR Fireplace Installation Do not Install the CFX Model in a Bedroom or BathroomClearances and Height Requirements General Installation Information Remove ScreenInstall Mantel Firebox to Mantel Installation Install Optional Firebrick Panels General Installation InformationConnect the GAS Installing gas piping to fireplace / burner system locationInstallation Items Needed Check gas typeConnect the GAS Check GAS Pressure Electrical Wiring Milli-volt Connecting Optional Wall Switch or ThermostatConnect Remote Receiver Check System OperationLOG Placement Proper installation sequence CFX24Clean LOG & Rockwool PlacementProper installation sequence CFX32Correct log flame appearance Flame appearanceCheck the pilot flame Check the Burner Flame Operating InstructionsWhat to do if YOU Smell GAS Operating InstructionsMILLI-VOLT Control Lighting Instructions Cleaning and Servicing Match Lighting InstructionsForced Air Kit Blower and Other Optional EquipmentOptional Equipment FirebricksTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting Replacement Parts CFX24 CFX32Replacement Parts Replacement Parts are Available Through Your Retailer Replacment PartsCFX Vent Free Fireplace System CFX Vent Free Fireplace System Basic Warranty Lifetime WarrantyFive Year Warranty If Warranty Service is NeededMhsc