Jwin JX-CD8700 owner manual Digital Clock and Timer Compact Disc Changer, Tuning SKIP/SEARCH, Play

DIGITAL CLOCK AND TIMER

COMPACT DISC CHANGER

Setting the digital clock

When you first plug in the unit, the display shows:

To set the clock to the current time proceed as follows:

1.Press MEM./CLK ADJ. The hour flashes.

2.Enter the hour by pressing the buttons

TUNING + SKIP/SEARCH or

TUNING - SKIP/SEARCH.

3.Confirm the entry by pressing MEM./CLK ADJ. The minutes will flash.

4.Enter the minutes by pressing the buttons

TUNING + SKIP/SEARCH or TUNING - SKIP/SEARCH and confirm with MEM./CLK ADJ.

To switch to the clock display while in tuner and CD modes, press DISPLAY MODE. The time is displayed for approximately 10 seconds. The time is also displayed when the unit is turned off.

Setting the timer

You can set automatic switch-on and switch-off times with the built-in timer. Before you do this, be sure the clock is set correctly.

3.To set the minutes, press the MEM./CLK ADJ.

again and use TUNING + SKIP/SEARCH

and TUNING - SKIP/SEARCH to adjust. Confirm by pressing MEM./CLK ADJ.

4.Press DISPLAY MODE to proceed to setting the switch-off time.

5.Set the switch-off time using the same procedure as switch-on time setting.

6.Press DISPLAY MODE, as required to check the current time, Timer On, and Timer Off.

7.Press TIMER (22)/(54) to activate the timer.

When the unit is on standby it will automatically switch on for the programmed length of time. The unit automatically selects the operating mode (CD or TUNER) it was in when last switched off. Make sure the tuner is tuned to a radio station, or for CD operation, a CD must be inserted.

Snooze function: When the unit is switched on by means of the timer, you can press the SNOOZE button (23)/(37) to switch the unit off for approximately 9 minutes. After this time, the unit switches on again. You can press SNOOZE again, or switch the unit off by pressing POWER.

Safety notes for operation of the CD changer

Press one of the "OPEN / CLOSE" buttons (15) or

(16)to open the right or left CD cover (2) or (26). The right and left CD cover do not opened or closed at the same time. Make sure the cover is not obstructed by any objects. This must also be ensured when closing the CD cover. The disc loader may only be opened or closed by pressing either the button "OPEN / CLOSE". Take care that no foreign objects can fall into the unit when the disc compartment is open.

Under no circumstance should the laser pick up lens be touched. Never look directly at the beam.

CD changer operation

Switch the unit on by pressing the “POWER” button (1)/(32). To turn on the CD mode, press the

button “ PLAY / PAUSE” (13)/(38) or any

one of the DISC 1-4 buttons (5) or (49). If one or more CD(s) have already been inserted in the chosen location(s), playback is started.

(TOC means Table of Contents) If there is no CD inside, the following will appear after a few seconds:

Inserting and ejecting the CD

Then close the disc compartment by pressing the “OPEN / CLOSE” button (15) or (16).

After having closed the disc cover, the CD system immediately begins to scan the content of the compact disc. Subsequently, the number of tracks and the play-back time of the compact disc occupying position 1 appear in the display unit (3).

Playing the entire CD

Select the desired CD with the button “CD SELECTION 1 - 4” (5) or “DISC 1 - 4” (49) on the remote. Playback begins automatically.

If the playback of one CD has finished, the playback of the next inserted CD begins, and so on.

Note: If the CD player is in stop position, you can start the currently indicated CD by pressing the

button “ PLAY / PAUSE” (13)/(38).

If you select a different CD by pressing the buttons “CD SELECTION 1 - 4” (5) or “DISC 1 - 4” (49), playback will start automatically.

Pause / stop

To briefly interrupt playback, press “ PLAY /

1.With the unit on, press DISPLAY MODE (17)/ (48), as required, until TIMER ON appears in the display.

2.Press MEM./CLK ADJ. (50). The hour flashes.

Use the TUNING + SKIP/SEARCH or TUNING - SKIP/SEARCH to set the hour of the desired switch-on time.

Setting the sleep timer:

When the unit is in operation it can be set to automatically switch-off 10 to 120 minutes later. Press SLEEP (25)/(52), as required, until the desired delay time appears on the display. The SLEEP timer can be set for: 120, 90, 60, 50, 40, 30, 20, and 10 minute intervals. The unit automatically turns off after the entered time has elapsed.

The CD compartment (2)/(26) is opened for inserting or removing compact discs by pressing the "OPEN / CLOSE" (15) or (16) button.

Insert the disc with the unlabelled side facing the unit. Press the centre of the CD onto the black holder that is fitted with 3 retaining bearings.

To remove the CD, hold it by the edges and lightly

PAUSE” button (13)/(38). The display indicates:

Press “ PLAY / PAUSE” button again to restart play.

To end the playback, press the “ STOP” button (11)/(45).

11

press on the holder to remove it.

12