Jwin JX-CD8700 owner manual Care and Maintenance

4.Press the “ TUNING + or TUNING -” button (18) or (20) to select desired track.

5.Press the “PLAY/PAUSE” button to play MP3.

Pause / stop

To briefly pause playback, press the “ PLAY

/PAUSE” button (13)/(38). Display indicates:

Press the “REPEAT” button again to have the entire MP3 disc played continuously.

Press the “REPEAT” button again to have all the inserted MP3 discs played continuously.

3.Select the desired title using the numeric buttons “0 - 9 / +10” (33) on the remote control device or by repeatedly pressing “

TUNING + or TUNING - ”.

4.Press the “MEM./CLK ADJ.” (9)/(50) to save the title on the first program location. In display unit (3) appears:

5.Confirm selection using the “MEM./CLK ADJ.” button (9)/(50).

6.To store the remaining titles in the memory, repeat steps 3 - 5.

To play back the program, press the “		PLAY
/ PAUSE” button (13)/(38). When “	PLAY /

PAUSE” is pressed, the program can be played back again as long as MEMORY appears on the display unit (3).

To clear the programming (Resume Normal Playback):

The programming is erased by pressing the “ STOP” button (11)/(45) in the programming mode (until the MEMORY display disappears), or by opening the disc compartment.

Note:

REPEAT button (12)/(47) is not used for programming.

ID3 TAG (Artist/Title)

When an MP3 disc is playing, press the “MP3 MODE” button repeatedly. The track no., title and artist information will be shown in the display if disc information is available.

To resume normal play display, press the “MP3 MODE” button repeatedly until playing time reappears.

Press “	PLAY / PAUSE” button again to
restart play.
To end the playback, press the “		STOP” button
(11)/(45).

Playback in random sequence

Press the “RANDOM” button (35) on the remote control in stop condition to start random play.

By pressing button “ STOP” (11)/(45), the random playback is cancelled. This function can be switched off by pressing “RANDOM” button again.

Repeat

Press the “REPEAT” button (12)/(47) during MP3 playback to have the title currently being played at repeated continuously.

Title introduction

Press the “INTRO” button (34) during stop mode to playback the first 10 seconds of each title.

Press the “INTRO” push-button again and the CD player plays the current selected track.

Program memory

The built-in program memory enables up to 40 titles to be played from up to 4 CDs in the order of your choice. Any title can be stored more than once within one program.

1.Insert a CD in its compartment.

2.By pressing the button “MEM./CLK ADJ.” (9)/ (50) in the stop mode you can switch to programming mode.

CARE AND MAINTENANCE

Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with the shiny, unprinted side of the disc.

Do not attach adhesive tape, stickers etc., to the disc label.

Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to clean the disc. If necessary, use a CD cleaning kit.

If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).

When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc. Never wipe in circular motions.

To remove a disc from its storage case, press down on the centre of the case and lift the disc outs, holding it carefully by the edges.

Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth. Unlike conventional records. compact disc have no groove to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles.

15 16