Sunrise Global 13-05024, 13-05020 owner manual Installation Instructions, Install the Rear Panel

INSTALLATIONINSTRUCTIONS

INSTALL THE REAR PANEL

1.Always mount the rear panel horizontally.

2.Fix the rear panel on the selected location with screws supplied with the unit.

3.Be sure that the rear panel has been fixed firmly enough to withstand the weight of an adult of 60 kg (132.3 lbs.), furthermore, the weight should be evenly shared by each screw.

INSTALL THE DRAIN HOSE

50 mm (2”)			50 mm (2”)
		Right piping
Left piping	(Fig.2)
hole			hole

Wrenched

Bent

1. For a proper draining, the drain hose should be
placed at a downward slant.	Flooded

2.Do not wrench or bend the drain hose or flood its end in water.

3.The extended drainage pipe in the room should be wrapped with the insulating materials.

INSTALL THE PIPING HOLE

1.Make the piping hole 50 mm (2”) in the wall at a slight downward slant to the outdoor side. The center of the hole should be determined refer to Fig.2.

2.Insert the piping-hole sleeve into the hole to prevent the connection piping and wiring from being damaged when passing through the hole.

INSTALL THE CONNECTION PIPES

Connect the connection pipes with the relevant union pipes of the indoor unit of the indoor unit and tighten the flare nut of the connection pipes.

NOTE:

•Connect the connection pipes with the indoor unit firstly and the outdoor unit secondly.

•Be careful in bending the connection pipes, or you will damage the pipes.

•If the tightening torque is too big in tightening the flare nuts, leakage will happen.

ELECTRICAL WIRING

Note: Only an electrician can install the electrical circuit.

1.Open the surface panel.

2.Remove the wiring cover.

3.Route the power connection cord from the back of the indoor unit and pull it toward the front through the wiring hole for connection.

4.Connect as shown on diagram.

5.Reassemble the wiring cover.

15