Vermont Casting 2477 manual Floor Protection, Canada

Page 9

A flush-mounted sheet metal cover may be used on one side only. If covers must be used on both sides, each cover must be mounted on non-combustible spacers at least 1” (25 mm) clear of the wall. Your Dutchwest dealer or your local building inspector can provide de- tails of other approved methods of passing a chimney connector through a combustible wall. In Canada, this type of installation must conform to CAN/CSA-B365, Installation Code for Solid Fuel Burning Appliances and Equipment.

NOTE: Do not vent your Dutchwest stove into a factory- built (zero-clearance) fireplace. These appliances and their chimneys are specifically designed as a unit for use as fireplaces. It may void the listing or be hazard- ous to adapt them for any other use.

Floor Protection

A tremendous amount of heat radiates from the bottom plate of your Dutchwest stove. The floor area directly under and around the stove will require protection from radiant heat as well as from stray sparks or embers that may escape the firebox.

Heat protection is provided by the CFM Corporation Bottom Heat Shield. Spark, ember and thermal protec- tion must be provided by a floor protector constructed with noncombustible material as specified.

In the US and Canada most installations will require that the bottom heat shield must be attached. Only when the stove is placed on a completely noncombusti- ble surface such as unpainted concrete over earth may it be used without the heat shield.

Even when the bottom heat shield is installed, you must provide special protection to the floor beneath. For installation with the heat shield attached, use an approved 7/8” (22mm) noncombustible hearth pad with K = 0.84 BTU/in. ft2 hr. °F or an equivalent material with an R-value of at least 1.04. (Refer to “How to Deter- mine if Alternate Floor Protection Materials are Accept- able” section) The floor protector may be covered with a decorative noncombustible material if desired. Do not obstruct the space under the heater.

Protection requirements vary somewhat between the United States and Canada as follows:

U.S. Installations: The floor protector is required under the stove and must extend at least 16” from the front and left (loading door) side of the stove, and at least 6” from the right side and rear. (Fig. 12)

In Canada: a noncombustible floor protector is required under the heater also. The floor protector must extend 18” (457mm) from the front and left (loading door) side of the stove, and at least 8” (203mm) from the right side and rear. (Fig. 12)

Dutchwest Non-Catalytic Convection Heater

C

BB

A B A B

AA

U.S. Canada

A.16” 18” (457 mm)

B.6” 8” (203 mm)

C.

10”

10” (254 mm)

ST798

Minimum Dimensions for Noncombustible Floor Protectors (Width x Depth):

(7/8”/22mm thick min. with an R-value of at least 1.04)

Model

U.S.

Canada

 

 

 

2477

46¹⁄₂” x 45”

50¹⁄₂” x 49” (1238 mm x 1245 mm)

 

 

 

Fig. 12 Be sure to follow exactly the minimum floor protection requirements on all four sides of the stove.

A

ST799

Fig. 13 Combustible supporting timbers (A) may lie beneath fireplace hearths; such situations require additional floor protection.

Due to the side loading door, floor protector require- ments call for more protection on the left side than on the right. If you wish a more balanced look, increase the other side of the hearth as well. Do not reduce side protection under any circumstances.

How to Determine if Alternate Floor Protection Materials are Acceptable

All floor protection must be noncombustible (i.e. metals, brick, stone, mineral fiber boards, etc.). Any organic materials (i.e. plastics, wood paper products, etc.) are combustible and must not be used. The floor protection specified includes some form of thermal designation such as R-value (thermal resistance) or k-factor (thermal conductivity).

30002314

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Non-Catalytic Convection Heater Model Table of Contents Accessories Model SpecificationsInstallation Chimney TypesMasonry Chimneys Two Types of Connector Guidelines for Installing the Chimney ConnectorSingle-Wall Connector Prefabricated ChimneysDouble-Wall Connector Assembling Single-Wall Chimney ConnectorSecuring the Connector to a Prefabricated Chimney Securing the Connector to a Masonry Chimney Freestanding InstallationsFireplace Installations Above the Fireplace Wall Pass-Throughs Fireplace Installations Through the FireplaceCanada Floor ProtectionProcedure Fireplace InstallationsClearances Fireplace Installation ClearancesKeep the Stove a Safe Distance From Surrounding Materials Safe Ways to Reduce ClearancesConstruction Requirements Alcove InstallationsClearance Chart Reference Diagrams Designing a Safe InstallationChimney Connector Clearance Corner Parallel Installations Stove Clearance Side RearRight Side OnlyDutchwest Convection Heater Model Corner Parallel Installations Chimney Connector Side RearDutchWest Non-Catalytic Convection Heater Model #2477 Wall Heat Shield DimensionsAssembly Unpack the PartsAttach the Legs and Heat Shield Fan Kit Installation Operation Heater Controls and Features Air ControlDamper Function Successful Wood Burning Burn Only High-Quality FuelLoad Doors Use the Air Control Settings That Work Best for You How to Build and Maintain a Wood Fire Loading WoodBreak-in Fires Reloading and Reviving the Fire Lighting the FireSafe Ash Handling Remove Ashes FrequentlyCleaning the Glass MaintenanceAdjust the Door Latch Test and Repair the Door GasketsDamper Adjustment Primary Air Control AdjustmentAvoid Damaging the Glass Door Panel Inspect Regularly, Clean As Required Cleaning the Chimney SystemTWO Weeks Draft Management Single Venting Draft TestingFuel CreosoteDutchwest Convection Heater Dutchwest Convection Heater Months, whichever is longer Limited Lifetime Warranty

2477 specifications

The Vermont Castings 2477 is a highly regarded wood-burning stove that epitomizes both craftsmanship and modern technology, making it a favored choice among wood stove enthusiasts. This powerful yet stylish stove is designed to provide exceptional heating efficiency while enhancing the aesthetic appeal of any living space.

One of the standout features of the Vermont Castings 2477 is its innovative design that combines traditional aesthetics with contemporary functionality. The stove features a large viewing window, allowing for a mesmerizing view of the flames, which creates a warm and inviting ambiance in any room. Its cast iron construction not only adds to the classic look but also ensures durability and long-lasting performance.

The stove has an impressive heat output, capable of heating spaces of up to 2,500 square feet, making it suitable for both small and medium-sized homes. It comes equipped with an efficient EPA-certified combustion system, which dramatically reduces emissions and optimizes fuel use. This technology allows users to enjoy a longer burn time with less firewood, thus enhancing overall efficiency and making it an environmentally friendly option.

The Vermont Castings 2477 features a secondary combustion system that enhances the burning process. By introducing air into the firebox, it ensures that gases are consumed efficiently, resulting in a cleaner burn. The stove is also equipped with a built-in ash pan that simplifies cleanup, allowing users to easily dispose of the ash without the hassle of removing the entire firebox.

In terms of customization, owners appreciate the variety of finishes available, ranging from classic black to vivid enamel colors, allowing for personalization to match different home decors. Additionally, the stove includes adjustable air controls, which enable users to regulate the burn rate and heat output based on their specific needs.

Lastly, installation of the Vermont Castings 2477 is straightforward, and it can be fitted with various chimney configurations, further enhancing its versatility. With its combination of style, technology, and efficiency, the Vermont Castings 2477 wood stove represents an excellent investment for anyone looking to embrace the warmth and charm of a wood-burning heating solution in their home.
Top Page Image Contents