Vermont Casting 2822, 820 Install the Stove Front, Complete the Assembly, Install ON/OFF Switch

Vermont Castings Jefferson Direct Vent/Natural Vent Gas Heater

	PILOT ADJ
Left Burner Leg	TPTH
Injector Shoulder	TP
90°	TH	ST228
Fig. 43	Attach switch wires to valve.

Install the Stove Front

		The Front Plate attaches to the stove by four steel tabs
	ST353	that engage with corresponding cast ribs on the sides
		and bottom of the stove body. Position the Front about
Fig. 41 Be sure to maintain 90° angle at left burner leg.
		3Ó down from stove top and lift the plate to engage the
		upper tabs behind the adjacent ribs on the sides. (Fig.
	Complete the Assembly
		44) Then lower the plate into position, so that the
• Open the swiveling latches (cams) on the top left		lower tabs engage with the corresponding ribs at the
	and right corners of the glass frame.	bottom. (Fig. 45)
• Position the glass and frame against the firebox by		When properly installed, the bottom of the Stove Front
	placing the bottom edge on the brackets on the	cannot be pulled away from the sides without also
	bottom face of the firebox.	lifting it.

•Swing the assembly against the firebox, and close

the latches firmly against the pins protruding from	Upper Tabs
the firebox top.

Install ON/OFF Switch

The switch assembly parts are found in the parts bag.			3Ó
1. Attach switch assembly to left rear side of stove
shroud using two screws and existing holes in
shroud. (Fig. 42)
2. Run wires down back of stove, under bottom of rear
shroud to valve.			Control Door
3. Attach wires to valve terminals. (Fig. 43)			Lower Tabs Engage	ST229
			Ribs in Bottom
		Fig. 44 Install Stove Front.
Switch	Existing
Assembly			Side Rib
	Holes
			Front Tab	Stove Side
Screws	ST315	Stove Front		ST279
Fig. 42 Attach switch assembly to rear shroud.		Fig. 45	Engage with side ribs.

20002191 23