Vermont Casting 2550CE installation instructions Replace the Stove Gaskets as Needed

Encore Woodburning Stove

	Refractory Access Cover
Left Wedge	Right Wedge
	ST644

Fig. 35 Release the lower fireback by tapping out two wedges.

Fireback

ST645

Fig. 36 Remove the lower fireback through the front door opening.

6.Check the combustor’s honeycomb-like element for a buildup of fly ash. If any is evident, take the combustor outside and clean it by blowing air gently through it.

7.Inspect the element for damage or degradation. Although small hairline cracks will not affect per- formance, the element should be essentially intact. If the element is broken in pieces or has sections missing, it should be replaced. Call your local Ver- mont Castings’ Authorized Dealer for a replacement element.

While the catalytic element is removed, check the condition of the secondary air probe. Use an inspec- tion mirror to locate the probe within the combustion chamber. The probe should extend 25-38 mm (1” to

1¹⁄₂”) into the chamber and show no signs of deteriora- tion, such as warping, corrosion, or short length. (Fig.

37)A damaged secondary air probe can affect catalytic performance. If the probe needs replacement, contact your local dealer.

8.If the element is in good condition and clean, re-in- stall it in the stove and replace the refractory access cover.

9.Replace the fireback, install the two wedges, and replace the cast iron hood.

1"

ST559

Fig. 37 Use an inspection mirror to check the reflected view of the secondary probe.

10. Clean the chimney and chimney connector.

Operate the stove in your typical manner for two weeks, inspecting the chimney and the chimney connector frequently during this period.

If creosote is not building up as fast, it is likely the performance change was caused by fly ash deposits on the catalytic element. However, continue the inspec- tions of the chimney system for a few weeks to ensure proper performance continues.

If you continue to find a significant creosote buildup or if you continue to see excessive smoke from the chimney, the catalytic element will need to be replaced. Contact your nearest Vermont Castings’ Authorized Dealer for information about a replacement element.

NOTE: Use only the replacement catalyst supplied by a Vermont Castings dealer.

Replace the Stove Gaskets as Needed

Your Encore uses rope-type fiberglass gaskets to make a tight seal between some parts. With use, particularly on those parts that move, gaskets can become brittle and compressed and can begin to lose their effective- ness. These will need periodic replacement.

All of the gaskets are made of fiberglass. The sizes of replaceable gasket are listed below, along with their applications.

Gasket Diameter ...And the Parts it Seals

5/16” The griddle to the stove top (wire reinforced gasket)

3/8” The ash door to the front of

the ash drop

3/16” The outer glass panes to the doors

5/16” The damper to the

upper fireback; the front doors to the stove front; and the doors to each other.

24 30003842