Vermont Casting 1695CE Installation, Outside Air, What Kind of Chimney to Use, 2000970

Page 4
Installation

Vermont Castings Intrepid Multi-Fuel

Installation

SAFETY NOTICE: IF YOUR STOVE IS NOT PROP- ERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRIC- TIONS AND INSTALLATION INSPECTION REQUIRE- MENTS IN YOUR AREA.

Before you begin an installation, review your plans to see that:

•Your stove and chimney connector will be far enough from combustible material to meet all clear- ance requirements.

•The floor protector is large enough and is construct- ed properly to meet all requirements.

•You have all necessary permits from local authori- ties.

Your local building official is the final authority for ap- proving your installation as safe and determining that it meets local and state codes.

The metal label permanently attached to the back of every Vermont Castings stove indicates that the stove has been tested to current standards. The test stan- dard EN13240:2001 + A2:2004 for Europe. Clearance and installation information also is printed on the label. When the stove is installed according to the information both on the label and in this manual, local authorities in most cases will accept the label as evidence that the installation meets codes and can be approved.

However, codes vary in different countries. Before starting the installation, review your plans with the local building authority. You local dealer can provide any ad- ditional information needed.

IMPORTANT: Failure to follow these installation instructions may result in a dangerous situation, in- cluding a chimney or house fire. Follow all instruc- tions exactly, and do not allow makeshift compro- mises to endanger property and personal safety.

All local regulations, including those referring to national and European standards, need to be com- plied with when installing this stove.

Outside Air

In some modern, super-insulated homes, there is not enough air for combustion because of insufficient air infiltration into the building. Such air enters a home through unsealed cracks and openings. Kitchen or bath exhaust fans can compete with the stove for available air and compound the problem.

When poor draft is caused by a low infiltration rate, opening a ground floor window on the windward side of the house and in the vicinity of the stove will usually alleviate the problem.

Another solution is to install a permanent outside air supply to the stove and/or room. In some areas, in fact, bringing air for combustion from outside the home directly to the air inlet of the stove is required for new construction.

An outside air supply is not affected by pressure varia- tions within the house, and improved stove perfor- mance often results. An Outside Air Adapter Kit #33258 for the Intrepid II is available from your local Vermont Castings dealer.

What Kind of Chimney to Use

Your Intrepid Multi-fuel must be connected to a code- approved masonry chimney with a flue liner, to a relined masonry chimney that meets local codes, or to a pre- fabricated metal chimney. Whatever kind you use, the chimney and chimney connector must be in good condi- tion and kept clean. Figure 2 shows the two chimney types.

A prefabricated double- wall insulated chimney

A tile-lined masonry chimney

ST241

Fig. 2 Standard chimney types.

If you use an existing masonry chimney, it must be inspected to ensure safe condition before the stove is installed. Your local professional chimney sweep, building inspector, or fire department official will be able to inspect the chimney or provide a referral to someone who can.

The flue and chimney design must meet requirement J2, Part J of the building regulations 2000 (Combustion Appliances and Fuel Storage Systems).

4

2000970

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Multi-FuelHeater Model 1695CEInstallation The IntrepidTable of Contents WelcomeVermont Castings Intrepid Multi-Fuel All of us at CFM CorporationSpecifications Intrepid Multi-Fuel,Model 1695CE, 1696CE, 1697CEVermont Castings Intrepid Multi-Fuel 2000970Installation Outside AirWhat Kind of Chimney to Use Vermont Castings Intrepid Multi-FuelChimney Connector Guidelines Double-wallChimney ConnectorMasonry Chimneys Prefabricated ChimneysSingle-wallChimney Connector Securing the Single-wallConnector to aFreestanding Chimney Installations Prefabricated ChimneyFireplace Chimney Installations Above a Fireplace Fireplace Chimney InstallationsThrough a Fireplace Wall Pass-ThroughsFloor Protection for Fireplace Installations HearthsVermont Castings Intrepid Multi-Fuel 2000970Keep the Stove a Safe Distance from Surrounding MaterialsClearances Summary of ClearancesVermont Castings Intrepid Multi-Fuel Connecting Flue Pipe - Clearances2000970 Assembly Clean the Griddle Before UseSet Up the Stove Install the Bottom Heat ShieldOperation Attach the Griddle HandleIntrepid Multi-fuel’sControls Primary Air ControlGlass Door Panels Front GrateTwo Ways to Add Fuel Vermont Castings Intrepid Multi-FuelHow to Build a Wood Fire and Keep It Going Conditioning Your StoveIntrepid Multi-FuelControl Settings Vermont Castings Intrepid Multi-FuelRefuel While the Embers Are Still Hot Ash DisposalVermont Castings Intrepid Multi-Fuel 2000970Draft Management Steel ChimneyIndoor/Outdoor location Flue sizingDraft Testing FuelBackpuffing Negative PressureMaintenance Cleaning the GlassGlass Replacement Care of the Cast Iron SurfaceHow to Adjust the Door Latch Damper AdjustmentTighten the Damper Handle as Needed Replace the Stove Gaskets as NeededAdjust the Door if Necessary Permanent GasketsVermont Castings Intrepid Multi-Fuel 2000970Annual Maintenance The Chimney SystemCreosote Vermont Castings Intrepid Multi-FuelIntrepid Multi-FuelHeater Model 1695CEVermont Castings Intrepid Multi-Fuel 2000970Intrepid Multi-FuelHeater Model 1695CE continuedVermont Castings Intrepid Multi-Fuel 2000970Intrepid Multi-FuelHeater Vermont Castings Intrepid Multi-FuelModel 1695CE continued Shell Enamel Parts - Intrepid Multi-FuelVermont Castings Intrepid Multi-Fuel 2000970Vermont Castings Intrepid Multi-Fuel 2000970Warranty Limited 3 Year WarrantyLimited 1 Year Warranty Limited Catalyst WarrantyCFM Corporation
Top Page Image Contents