Vanguard Heating VS24PR, VS30PR, VS18PR installation manual Safety, Information

Page 3

SAFETY

WARNINGS Continued

INFORMATION

WARNING: Any change to this heater or its controls can be dangerous.

Continued

1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not

convertible for use with other gases.

 

2.Do not place propane supply tank(s) inside any structure. Locate propane supply tank(s) outdoors.

3.If you smell gas

•shut off gas supply

•do not try to light any appliance

•do not touch any electrical switch; do not use any phone in your building

•immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions

•if you cannot reach your gas supplier, call the fire department

4.This heater shall not be installed in a bedroom or bathroom.

5.Never install the heater

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

•in high traffic areas

•in windy or drafty areas

6.Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. Inspect chimney flue for damage. If damaged, operate heater with flue damper closed.

7.If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fireplace will cause glass to burst. Also if fireplace opening has vents at the bottom, you must open the vents before operating heater.

8.You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.

9.This log heater is designed to be smokeless. If logs ever appear to smoke, turn off heater and call a qualified service person. Note: During initial operation, slight smoking may occur due to log curing and heater burning manufacturing residues.

10.Do not allow fans to blow directly into the fireplace. Avoid any drafts that alter burner flame patterns. Ceiling fans may create drafts that alter burner flame patterns. Altered burner patterns can cause sooting.

11.Do not use a blower insert, heat exchanger insert or other accessory not approved for use with this heater.

12.This heater needs fresh, outside air ventilation to run properly. This heater has an oxygen depletion sensor (ODS) pilot light safety system. The ODS shuts down the heater if not enough fresh air is available. See Air for Combustion and Ventilation, pages 5 through 7. If heater keeps shutting off, see Troubleshooting, pages 23 through 25.

13.Do not run heater

•where flammable liquids or vapors are used or stored

•under dusty conditions

14.Do not use this heater to cook food or burn paper or other objects.

15.Never place any objects on the heater.

16.Heater base assembly becomes very hot when running heater. Keep children and adults away from hot surface to avoid burns or clothing ignition. Heater will remain hot for a time after shutpdown. Allow surface to cool before touching.

17.Carefully supervise young children when they are in the room with heater. When using the hand-held remote accessory, keep remote selector switch in the OFF position to prevent children from turning on burners with hand-held remote control unit.

18.Do not use heater if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water.

19.Do not operate heater if any log is broken. Do not operate heater if a log is chipped (dime-sized or larger).

20.Turn heater off and let cool before servicing, installing, or repairing. When using the hand-held remote accessory, make sure the remote selector switch is in the OFF position. Only a qualified service person should install, service, or repair heater.

21.When using the hand-held remote accessory, make sure the remote selector switch is in the OFF position when you are away from home for long periods of time.

22.This heater must not be connected to any external electrical source.

23.Operating heater above elevations of 4,500 feet may cause pilot outage.

24.To prevent performance problems, the use of a propane fuel tank of less than 100 lb. capacity is not recommended.

3

103448

Page 2 Page 4
Image 3
Page 2 Page 4
Contents What to do if YOU Smell GAS VS18PR VS24PR VS30PRContents Information SafetyOperation Unpacking Product FeaturesSafety Pilot Local CodesConfined Unconfined Space AIR for Combustion and VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining if You Have a Confined or Unconfined Space Determining AIR Flow for Heater LocationVentilation AIR AIR forCombustion VentilationCheck GAS Type InstallingMinimum Wall and Ceiling Clearances see Figure Installing Installation and ClearancesMinimum Fireplace Clearance To Combustible Materials LOG Sizing RequirementsInstalling If Using MantelMinimum Non Combustible Material Clearances See Figure Installing Mantel ClearancesFloor Clearances Installing Heater Base AssemblyAttaching Base to Fireplace Floor Installation Items Needed Connecting to GAS SupplyGas Connection Checking GAS ConnectionsTest Pressures Equal To or Less Than 1/2 Psig Pressure Testing gas Supply Piping systemPressure Testing Heater Gas Connections Test Pressures In Excess Of 1/2 PsigMetal Grate Bar Installing Installing LogsFor Your Safety Read Before Lighting Installing OperatingHeater Control Knob and Ignitor Button Location Lighting InstructionsShutting Off Heater Manual Lighting ProcedureTo Turn OFF GAS to Appliance Thermostat Control OperationOperating Heater Optional Ghrct Hand Held Remote OperationInspecting Burners Pilot Flame PatternFront Burner Flame Pattern ODS/PILOT and Burners CleaningMaintenance Turn off heater and let cool before cleaningShooting TroubleShooting TroubleService Hints Wiring DiagramTechnical Service SpecificationsParts Under Warranty Replacement PartsIllustrated Parts BreakdownKEY Part Numbers VS18PR VS24PR VS30PR Description QTY Parts ListAccessories 103448 Limited Warranty VENT-FREE Propane GAS LOG Heaters Warranty Information

VS18PR, VS30PR, VS24PR specifications

Vanguard Heating offers a range of high-performance heating solutions, including the VS30PR, VS18PR, and VS24PR models. Each unit is engineered to deliver exceptional efficiency and reliability for both residential and commercial heating needs.

The VS30PR model is designed for medium-sized spaces, delivering up to 30,000 BTUs. Its compact design makes it an excellent choice for both homes and businesses where space is at a premium. The VS30PR is equipped with advanced modulating technology, allowing it to adjust its heating output based on the current demand, which significantly enhances energy efficiency. One of its key features is the electronic ignition system that eliminates the need for a standing pilot light, thus enhancing safety and reducing gas consumption.

On the other hand, the VS18PR model is tailored for smaller applications, providing a heating output of up to 18,000 BTUs. This model excels in energy conservation, having earned high efficiency ratings. It includes an integrated fan system that ensures uniform heat distribution throughout the space, mitigating cold spots and enhancing comfort. The VS18PR is ideal for homes with limited heating requirements or smaller commercial spaces. Its durable construction and reliable operation make it a popular choice for those seeking a dependable heating solution without unnecessary excess.

The VS24PR model offers a balanced option for larger areas with a heating capacity of up to 24,000 BTUs. It features dual fuel options, allowing users to switch between natural gas and propane, providing versatility depending on the available fuel source. The VS24PR also includes advanced control systems that allow for programmable settings, enabling users to optimize their heating schedules based on their lifestyle and preferences. An outstanding feature of this model is its compatibility with smart home systems, allowing for remote monitoring and control via smartphone applications.

Overall, Vanguard Heating’s VS30PR, VS18PR, and VS24PR models embody the brand’s commitment to quality, efficiency, and customer satisfaction. Each model incorporates innovative technologies that cater to varying heating needs, ensuring users can find an appropriate solution for their specific requirements. With robust designs and advanced features, these units not only enhance comfort but also contribute to reduced energy costs. Whether for a cozy home setting or a bustling commercial environment, Vanguard Heating’s offerings stand out for their performance and reliability.
Top Page Image Contents