UVS33/36
Optional Accessories
Fan Kits
FK12 Fan Kit
This auxiliary fan system increases the efficiency of the circulation of the heating air. The FK12 Fan Assembly is a fixed speed fan system and does not allow for vari- able speed control. It does not use the speed control unit or the heat sensor used in the FK24 kit.
Specifications
115 Volts / 60 Hz / .75 Amps.
Installation
The fan assembly is supplied fully wired eliminating the need for a licensed electrician to carry out the installa- tion.
1.Open the lower louvre assembly. Maneuver the fan & bracket assembly around the gas valve and lines to locate the unit against the back wall of the appli- ance, resting on the base.
2.With the protective cover removed from the
3.Power to the fan can be supplied by plugging the supply lead into a conveniently located wall socket or by using a
FK24 Fan Kit
This auxiliary fan system increases the efficiency of the circulation of the heating air.
The FK24 fan kit allows variable speed control of the circulation fan and also incorporates a heat sensor in the circuit.
Specifications
115 Volt / 60Hz / .75 Amps
Installation
The fan assembly and other components are supplied fully wired eliminating the need for a licensed electrician to carry out the installation.
If hard wiring the fan in using Method B (following) we strongly recommend the use of a licensed electrician.
1.Open the lower louvre assembly. Maneuver the fan & bracket assembly around the gas valve and lines to locate the unit onto the screw studs on the back of the fireplace.
2.Install the thermal sensor under the bottom of the
3.Locate the fan speed control unit. This can be fitted behind the lower louvre assembly or located remotely in a conveniently located wall mounted electrical box. Remote location of the
speed control will require suitable extension of the component wiring.
4.The power supply may be connected in two ways:
Method A
Route the 6’ lead fitted to the unit to a conveniently located wall socket.
Method B
The
Electrical Connection
The
Remote Controls
Optional remote control units are available to control different functions of the appliance.
Model | Function(s) Controlled |
RC1 | ON/OFF |
RC2 | ON/OFF and Temperature |
IMTFK | Wall mounted thermostat control |
Outside Air Termination
The
Ceramic Brick Liner
Ceramic panels are available to line the firebox area.
Model 33BDVCR
Decorative Bay Screen Kit
The 33BSTK Bay Window Screen Kit is available to
place on the front of the unit.
firebox, locating it over the two 10 mm studs and secure it with nuts.
20002211 | 19 |