UVS33/36
Decorative Frame Trims
A selection of decorative frame trim kits are available for mounting around the outside of the appliance to en- hance its visual effect on the room. Installation instruc- tions for each decorative frame trim are included with the frame trim kit.
Unit | Kit Model |
UVS33 | DV33GTP, DV33GTA, DV33GTS, |
| DV33TKP, DV33TKMP, |
| DV33TKMA, DV33TKMS, |
| DV33TKMB, DV33TKWP, |
| DV33CBTK |
UVS36 | DV36GTP, DV36GTA, DV36TKP, |
| DV36TKA, DV36KMP, DV36KMA |
| DV36KWP, DV36KWA |
Glass/Catalyst Kit
Only glass approved by CFM Corporation should be used on this fireplace.
•The use of any
•Care must be taken to avoid breakage of the glass.
•Do not operate appliance with glass front re- moved, cracked or broken.
•Replacement glass (complete with gasket) is available through your CFM Corporation dealer and should only be installed by a licensed quali- fied service person.
UVS 36GCFK
1.Turn unit "OFF".
2.Remove the top louvre. Refer to Page 11, Figure 15.
3.Remove the window frame. Refer to Page 11, Figure 16.
4.Remove the deflector firebox by removing the three
(3)screws securing it to the firebox top. (Fig. 22)
5.Install a catalyst up through one of the rectangular holes in the firebox top. (Fig. 23)
6.While holding the catalyst in place, slide the cata- lyst bracket over the studs and secure with the nuts provided. (Fig. 23)
7.Repeat Steps 5 and 6 for second catalyst.
8.Install the deflector firebox with screws removed earlier.
9.Install the glass door as provided in kit.
10.Install the top louvre.
Installation complete.
Deflector Firebox
FP1477
Fig. 22 Remove deflector firebox.
Catalyst
Catalyst Bracket
NutsFP1478
Fig. 23 Install catalyst and bracket in place, secure with nuts provided.
20 | 20002211 |