Amcor A12000EH owner manual Operation, Setting the Timer, Setting the Operating Mode, Fan Speed

water full

Operation

MODE		ON/OFF
	TIMER	FAN
		SPEED

3 2 5 4 1

1. ON/OFF

Press the on/off-button to switch the unit on or off.

2. Setting the Timer

Press the timer button, which will start the timer counter function.

Each press of the timer button will advance the timer setting by 1 hour, for setting 1-12 hours. If you pass the desired hour setting, you must advance the numbers completely through 12, to start timer count from 1. When set, the timer led will light up.

When the set hours have elapsed, the unit will turn off automatically.

The display will show the hour(s) remaining when you press the timer button.

By pressing the timer button but without turning the unit on, you can pre-set in how many hour(s) the unit will switch on automatically.

3. Setting the Operating Mode

Select the required operating mode: cool, heat, fan, or auto. The corresponding led will lit. In auto mode the unit will select cooling, heating, or fan depending on the ambient temperature.

4. Fan Speed

Select the fan speed, the corresponding led will lit: low or high.

5. Increase UP or DOWN

When the unit is ON, the display always shows the room temperature. Press button UP or DOWN to see the current set temperature and adjust if necessary, in the range of 62ºF to 90ºF. After 8 seconds, the room temperature will be displayed.

Warning lights COMPRESSOR and WATER FULL

When the water container is full, the unit automatically stops, the warning light

will flash to signal that the container must be emptied (see page 9, “Emptying The Water Container”).

When the unit is cooling, the compressor light will be on. If this light is off further cooling is not needed at this time, or the compressor may be de-icing its coils.

The fan can still be on.

7