Amcor A12000EH owner manual Positioning, Installing Exhaust Hose to Window Slide Bar

Page 8

Positioning

This unit can easily be moved from one room to another. In doing so keep this in mind:

The air conditioner must stand upright on an even surface.

Do not position near bath, sink, or other permanent wet or damp area.

Keep unit at least 18" from wall, curtains, draperies, to insure adequate air circulation.

1

2a

2b

Installing Exhaust Hose to Window Slide Bar

After assembling Innovative AutoDrain NanoMist Technologyper instructions on page 5, make sure hose is firmly attached to oval connecter that fits into window slide bar.

Snap hose connecter into window slide bar opening. See Illustration 1.

Extend window slide bar to fit your window opening, either vertical or horizontal, depending on how the window opens. See Illustrations 2a-2b.

Important

The flexible exhaust hose can be extended from 12" to 60" for mounting.

This length has been designed especially according to the specifications of the air conditioner.

Do not use an extension or exchange for a different hose as that may lead to malfunctioning.

The exhaust air must flow freely, any blockage can lead to overheating of the air conditioner. Take care to prevent any kink or bend in the exhaust hose.

6

Image 8
Contents Portable Air Conditioner Table of Contents Safety Instructions Thank YouSafety ReminderSpecifications Parts AutoDrain NanoMist Technology Assembly Only Required For DisassemblyInstalling Exhaust Hose to Window Slide Bar PositioningSetting the Timer Setting the Operating ModeOperation Fan SpeedRemote control Air flowSwitch off the unit and remove the plug from the outlet Emptying The Water ContainerCleaning Installation of Carbon FilterHousing FilterStorage Troubleshooting Page One Year Limited Warranty 5 Years for Compressor Only Product Portable Air ConditionerManual del propietario Índice Agradecimientos Instrucciones de seguridadSeguridad RecordatorioEspecificaciones Modelo NanoMaxA12000EHPartes Ensamblaje de la función AutoDrain NanoMist Technology Paso requerido para el desarmado únicamentePosicionamiento Funcionamiento Ajuste del relojAjuste del modo de funcionamiento Velocidad del ventiladorImportante Unidad de control remotoFlujo de aire Vaciado del recipiente de agua Apague la unidad y retire el tapón de la salidaLimpieza Instalación de filtro de carbónCubierta FiltroAlmacenaje Identificación y resolución de problemas Problema Causa SoluciónPage 02/2008