PREPARATION
Set the Current Time and Day
1Press the CLOCK ADJUST button for more than three seconds.
2Press the TEMP./DAY button and set the day.▲: Use to advance the day forward.
▼: Use to turn the day back.
The day is indicated by a code number from 1 to 7, as shown in the table below. Set to the number that corresponds to the current day.
DAY CODE | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
DAY OF THE WEEK | MON | TUE | WED | THU | FRI | SAT | SUN |
3 | Press the SET TIME button and set the time. |
▲: Use to advance the time forward. | |
| ▼: Use to turn the time back. |
| (Press once to move the time 1 minute; hold down and the time will move |
| 10 minutes at a time.) |
4 | Press the CLOCK ADJUST button again. |
This registers the new day and time values. The day display goes off, and |
the time display stops flashing.
AM | CLOCK |
|
| DAY |
|
TIMER | SET TIME TEMP./DAY | FAN |
MODE |
| CONTROL |
MASTER
CONTROL
CLOCK ADJUST
ZONE | ENERGY SAVE START/STOP |
1 3SET DAY2OFF
AM CLOCK
Example: Set the time to 9:31.
OPERATION
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
To Select Mode Operation
1 | Press the START/STOP button. |
The unit will start and the remote controller’s operation lamp (green) will |
light up.
2Press the MASTER CONTROL button to select the de- sired mode.
| s |
| s |
|
|
|
| AUTO |
| *HEAT |
| ||
| COOL | t |
| t |
| |
|
|
| ||||
|
|
| FAN | |||
To Set the Thermostat
Press the TEMP./DAY button to the desired temperature.
▲: Press to raise the thermostat setting. ▼ : Press to lower the thermostat setting.
●Thermostat setting range:
AUTO | 64 to 88 °F |
* Heating | 60 to 88 °F |
Cooling/Dry | 64 to 88 °F |
The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the remote controller’s display).
The thermostat setting should be considered a standard value, and may differ somewhat from the actual room temperature.
NON STOP AM | CLOCK | AUTO |
|
| °F |
|
|
TIMER | SET TIME TEMP./DAY | FAN |
|
MODE |
| CONTROL |
|
|
| MASTER |
|
|
| CONTROL |
|
CLOCK ADJUST |
|
| 2 |
| ZONE | ENERGY SAVE START/STOP | |
| SET | DAY OFF |
|
Example: When set to AUTO | 1 | ||
| |||
NON STOP AM | CLOCK | AUTO |
| °F |
|
TIMER | SET TIME TEMP./DAY | FAN |
MODE |
| CONTROL |
|
| MASTER |
|
| CONTROL |
CLOCK ADJUST |
|
|
| ZONE | ENERGY SAVE START/STOP |
| SET | DAY OFF |
Example: When set to 84 °F