PREPARATION
Load Batteries (R03/LR03/AAA ⋅ 2)
1 | Press and slide the battery compartment lid on the re- | |
verse side to open it. |
| |
| Slide in the direction of the arrow while pressing the mark. | |
2 | Insert batteries. |
|
Be sure to align the battery polarities ( | ) correctly. | |
3 | Close the battery compartment lid. | |
Set the Current time
1 | Press the TIME ADJUST button. | |
Use the tip of a | ||
2 | Use the ( | ) SET TIME buttons to adjust the clock |
to the current time. | ||
| button: Press to advance the time. | |
| button: Press to reverse the time. | |
| (Each time the buttons are pressed, the time will be advanced/reversed in | |
| ||
| quickly in | |
3 | Press the TIME ADJUST button again. | |
This completes the time setting and starts the clock. | ||
To Use the Remote Control Unit
●The remote control unit must be pointed at signal receiver to operate correctly.
●Operating range: About 7 meters.
●When a signal is properly received by the air conditioner, a beeping sound will be heard.
●If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
CAUTION!
●Take care to prevent infants from accidentally swallowing batteries.
●When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.
●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.
●Dead batteries should be removed quickly and disposed of properly, either by placing in a public battery collection receptacle, or by returning to appropri- ate authority.
●Do not attempt to recharge dry batteries.
Never mix new and used batteries, or batteries of different types.
Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appre- ciably reduced, replace the batteries and press the ACL button with the tip of a ballpoint pen or other small object.
Insert
Slide up
Press in | Pull out |
Screws
1Mount the Holder. 2 Set the Remote Control Unit. 3 To remove the Remote
Control Unit (when use at hand).