Fujitsu AOU18RL Operating Tips, Operation and Performance, Auto Restart, Heating Performance

Page 17

TROUBLESHOOTING

 

Symptom

Items to check

See Page

 

 

 

 

CHECK ONCE

Doesn’t operate at all:

● Is the Power Supply Plug disconnected its outlet?

 

MORE

 

● Has there been a power failure?

 

 

● Has a fuse blown out, or a circuit breaker been tripped?

 

 

 

 

 

 

 

● Is the timer operating?

7 - 8

 

 

 

 

 

 

● Is the Air Filter dirty?

 

 

 

● Air the air conditioner’s intake grille or outlet port blocked?

 

 

Poor Cooling performance:

● Did you adjust the room temperature settings (thermostat) cor-

 

 

 

rectly?

 

 

 

● Is there a window or door open?

 

 

● In the case of Cooling operation, is a window allowing bright sun-

 

 

 

light to enter? (Close the curtains.)

 

 

 

● In the case of Cooling operation, are there heating apparatus and

 

 

 

computers inside the room, or are there too many people in the

 

 

 

room?

 

 

 

 

 

 

 

● Is the unit set for SUPER QUIET operation?

5

 

 

 

 

 

The unit operates

● Are the Remote Control Unit’s batteries dead?

 

 

differently from the Remote

● Are the Remote Control Unit’s batteries loaded properly?

4

 

Control Unit’s setting:

 

 

 

 

 

 

If the problem persists after performing these checks, or if you notice burning smells, or the TIMER Indicator Lamp (Fig. 3 6) and OPERATION Indicator Lamp (Fig. 3 5) flashes, immediately stop operation, disconnect the Power Supply Plug, and con- sult authorized service personnel.

OPERATING TIPS

Operation and Performance

Heating Performance

Microcomputer-controlled Automatic Defrosting

This air conditioner operates on the heat-pump princi- ple, absorbing heat from outdoor air and transferring that heat indoors. As a result, the operating performance is reduced as outdoor air temperature drops. If you feel that insufficient heating performance is being produced, we recommend you use this air conditioner in conjunction with another kind of heating appliance.

Heat-pump air conditioners heat your entire room by recirculating air throughout the room, with the result that some time may be required after first starting the air con- ditioner until the room is heated.

When using the Heating mode under conditions of low outdoor temperature and high humidity, frost may form on the outdoor unit, resulting in reduced operating per- formance.

In order to prevent this kind of reduced performance, this unit is equipped with a Microcomputer-controlled Auto- matic Defrosting function. If frost forms, the air condi- tioner will temporarily stop, and the defrosting circuit will operate briefly (for about 7-15 minutes).

During Automatic Defrosting operation, the OPERATION Indicator Lamp (red) will flash.

AUTO Restart

In Event of Power Interruption

The air conditioner power has been interrupted by a power failure. The air conditioner will then restart auto- matically in its previous mode when the power is restored.

Operated by setting before the power failure.

If a power failure occurs during TIMER operation, the timer will be reset and the unit will begin (or stop) operation at the new time setting. In the event that this kind of timer fault occurs the TIMER Indicator Lamp will flash (see Page. 3).

Use of other electrical appliances (electric shaver, etc.) or nearby use of a wireless radio transmitter may cause the air conditioner to malfunction. In this event, temporarily disconnect the Power Supply Plug, reconnect it, and then use the Remote Control Unit to resume operation.

En-14

05L256_9315255013-01_En

14

2005.12.9, 11:49 AM

Image 17
Contents Español Français English Operating ManualSafety Precautions ContentsOperation Timer Super Quiet Coil DRY Especificaciones SpecificationsFiche Technique Inverter Features and FunctionsIndoor Unit Operating Control Panel Fig Manual Auto button Name of PartsPreparation Operation About Auto Changeover Operation About Mode OperationTo Stop Operation Press the START/STOP button R Timer Operation About the Sleep Timer Sleep Timer OperationDuring Heating operation During Cooling/Dry operationVertical Air Direction Adjustment Press the SET button S Adjusting the Direction of AIR CirculationRight-Left Adjustment Adjust the Right-Left louvers Types of Air flow Direction SettingCoil DRY Operation Swing OperationManual Auto Operation To select Swing Operation Press the Swing button TCleaning and Care Install the two Air filters and close the Intake Grille Install the Air cleaning filter set setReplacing dirty Air cleaning filters Replace them by two new Air cleaning filtersSymptom Problem TroubleshootingOperating Tips Event of Power InterruptionOperation and Performance Auto RestartCooling Mode Dry Mode Heating Mode Outdoor temperature Temperature and Humidity RangeIndoor temperature Tips for saving energy05L2569315255013-01En 2005.12.9, 1149 AM