Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Light (red)
5 TIMER Indicator Light (green)
6 SWING Indicator Light (orange)
(HORIZONTAL SWING)
7 SWING Indicator Light (orange)
(VERTICAL SWING)
●If the TIMER indicator light flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 17 Auto Restart).
8Intake Grille
9UP/DOWN Air Direction Flap
0RIGHT/LEFT Air Direction Louvers (behind UP/DOWN Air Direction Flap)
Fig. 4 Outdoor Unit
AIntake side B Outlet side
Fig. 5 Remote Control Unit 
CSLEEP Button
DMASTER CONTROL Button
ESET TEMP./SET TIME Buttons (
) F Signal Transmitter
G TIMER Button
H FAN CONTROL Button I START/STOP Button J Battery compartment lid
Inside of the battery compartment lid (Fig. 6)
KAIR FLOW DIRECTION Button L ENERGY SAVE Button
M CODE CHANGE (Slide Switch)
Switching the remote control unit code. (Max. 4 units)
N TIME ADJUST Button O TEST RUN Button
●This button is used when installing the air conditioner and should not be used under normal conditions as it will cause the air conditioner’s thermostat function to oper- ate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the indoor unit’s OPERA- TION indicator light and TIMER indicator light will begin to flash simultaneously.
●To stop the test operation mode, either press the TEST RUN button once again, or press the START/STOP button to stop the air conditioner.
PACL Button
QRemote Control Unit Display (Fig. 7) R Transmit Indicator
S Clock Display
T Operating Mode Display U Timer Mode Display V Fan Speed Display
W Temperature Set Display X Timer Set Indicator
Y Temperature Set Indicator