Preparation


Load Batteries (R03/LR03/AAA× 4)
1	Press and slide the battery compartment lid to open it.
2	Insert batteries.
	Be sure to align the battery polarities (		) correctly.
3	Close the battery compartment lid.
Set the Current time
1	Press the TIME ADJUST button.
	Use the tip of a ball-point pen or other small object to press the button.
2	Use the (	)SET TIME buttons to adjust the clock to
	the current time.

button: Press to advance the time. button: Press to reverse the time.

(Each time the buttons are pressed, the time will be advanced/reversed in one-minute increments; hold the buttons depressed to change the time quickly in ten-minute increments.)

CAUTION!

●Take care to prevent infants from accidentally swallowing batteries.

●When not using the remote control unit

for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.

●Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

●Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appre- ciably reduced, replace the batteries and press the ACL button with the tip of a ballpoint pen or other small object.

3	Press the TIME ADJUST button again.
	This completes the time setting and starts the clock.

To Use the Remote Control Unit

●The remote control unit must be pointed at signal receiver to operate correctly.

●Maximum operating range: Approximately 10 meters. (This may not apply when the battery is low or there is a obstacle.)

●When a signal is properly received by the air conditioner, a beep will be heard.

●If no beep is heard, press the remote control unit button again.

Remote Control Unit Holder

For Hand Held Use

Insert

Slide up

Screws
1 Mount the Holder.	2 Set the Remote	3	To remove the Remote
	Control Unit.		Control Unit.
For Wall Mount Use
	Insert
Screws			Slide
		Screw
1 Mount the Holder.	2 Set the Remote	3	Attach the unit to the
	Control Unit.		holder as shown.

SET

SWING

SET

ENERGY TIME	ACL
SAVE

En-6

PREPARATION

the current time.

To Use the Remote Control Unit

Remote Control Unit Holder

For Wall Mount Use