Height Adjustment, Fan Blade Cleaning | Holmes HASF2120RC manual

STEP 6: This fan is equipped with a 4-setting stop timer. (8 hrs, 4 hrs, 2 hrs, and 1 hr) To activate the timer, push the Timer button on the remote con- trol, or the Timer button on the touch-key pad. One push will set the 1 hr, the next push sets the 2 hr, the third push activates the 4 hr, and the fourth push sets the 8 hr. Push again to begin repeating this sequence.

NOTE: The timer can be used in conjunction with several

other functions. For example: SLEEP + 4HR. TIMER causes the fan to gradually slow down over 4 hours and eventually turn off.

ADJUSTMENT INSTRUCTIONS:

Height Adjustment:

Follow these instructions to adjust the height of the fan.

Step 1: Turn the extension pole base collar (see figure 3 and 5) counter-clockwise to loosen pole.

Step 2: Adjust the pole to the desired height, and firmly tighten collar in a clockwise direction.

CLEANING/MAINTENANCE INSTRUCTIONS:

Follow these instructions to correctly and safely care for your Holmes stand fan. Please remember:

•Always unplug the fan before cleaning or disassembling.

•Do not allow water to drip on or into the fan motor housing.

•Be sure to use a soft cloth moistened with mild soap solution.

•Do not use any of the following as a cleaner: gasoline, thinner, or benzine.

Fan Blade Cleaning:

(Instructions for fan head assembly, see figure 1)

STEP 1: To access the fan blade, remove the front grill and blade cap.

STEP 2: Clean the fan blade, front and rear grills with a soft, moist cloth.

STEP 3: Replace blade, tighten blade cap, and securely fasten the front grill.

Fan Head, Base, and Pole Cleaning:

Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.

FAN STORAGE:

Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location.

•If stored disassembled, we recommend using the original (or appropriately sized) box.

•If stored assembled or partially assembled, remember to protect the fan head from dust.