Figure 1 (HASF2120RC shown)
Pole Assembly:
B
AC
A. LOGO PLATE (SNAP ON) |
B. FRONT GRILL |
C. BLADE CAP |
D. FAN BLADE |
E. REAR GRILL |
MOUNTING RING |
F. PLASTIC BAND |
G. GRILL SCREW |
DH
J
EI
F
G
K.MOTOR HOUSING
L.TILT JOINT
M.FAN POST SCREW
N.REMOTE CONTROL HOUSING
O. EXTENSION POLE
P. BASE COLLAR
Q.BASE
R.FOOT EXTENSIONS (4) 
K
L
M
N
O
P
Q
R
STEP 1: Remove the base collar from the base
by turning counter- clockwise.
STEP 2: Take the extension pole, with the solid end down, and insert it into the base. The hollow end of the pole (with the screw hole) will be facing up.
Figure 3
Extension
Pole
Base
Collar
Base
H. REAR GRILL |
I. MOTOR SHAFT |
J. GRILL MOUNT |
STEP 3: Replace the base collar over the extension pole, slide it down the pole, and
ASSEMBLY INSTRUCTIONS:
Base Assembly:
You will need the base and four extension legs.
Push in the small tab on each extension and snap into base.
Figure 2
secure it to the base by turning clockwise.
Fan Head Assembly:
You are now ready to assemble the fan head (See Figure #1)
Step 1: Position the rear grill over the motor shaft, making certain the 2 notches at the top and bottom of the rear grill fit over the 2 prongs on the motor housing. Please make sure the rear grill fits securely against the motor housing.
Step 2: Secure the rear grill in its place using the rear grill mounting nut. Turn this nut clockwise and tighten firmly.
Step 3: Slide the fan blade, with the hollowed interior of the blade facing towards the rear grill firmly onto the motor shaft. Make sure the shaft protrudes from the front of the blade.