Installation
Instructions
“ | T H E | ” | SPREAD | 2881 | |
LAVATORY | |||||
| C O L L E C T I O N™ |
| |||
| by |
| FAUCET |
| |
|
|
|
|
Thank you for selecting
To ensure that your installation proceeds
Certified to comply with ANSI A112.18.1M
M968211
TOOLS REQUIRED
Channel Locks | Adjustable Wrench | Plumbers' Putty or Caulking | Phillips Screwdriver |
1 SPOUT ASSEMBLY
CAUTION
Turn off hot and cold water supplies before beginning.
Insert SPOUT SHANK (1) through center hole of SINK (2). Make sure RING WASHER (3) is properly positioned into SPOUT BASE.
Assemble RUBBER WASHER (4), | 7 | |
| ||
BRASS WASHER (5) and LOCKNUT (6) |
| |
onto threads of SPOUT SHANK (1) |
| |
from underside of SINK (2). |
| |
Insert LIFT ROD (7) through SPOUT (8) |
| |
and slot of BRASS WASHER (5). | 8 | |
Align SPOUT (8) and tighten LOCKNUT (6). | ||
| ||
Be sure slot in BRASS WASHER (5) is | 1 | |
positioned to the rear as shown. | ||
| ||
| 3 | |
2 | 4 | |
SLOT | 5 |
2 VALVE INSTALLATION
Insert VALVE BODY (1) through hole from underside of SINK (2). Threads of VALVE BODY (1) should extend at least 5/16 inch above SINK (2) top. If necessary, adjust LOCKNUT (3). Make sure RUBBER WASHER (6) is installed.
Place RUBBER RING (4) on SINK (2) and screw DECK ADAPTER (5) onto VALVE BODY (1) until snug against internal stop.
Set VALVE BODIES (1,1A) so that their outlets are facing toward center of sink and then tighten LOCKNUT
(3) using WRENCH (7) supplied with faucet.
5
4
5/16'' MIN.
2
6 |
73
1
| 6 |
3 TEE AND HOSE INSTALLATION | VALVE |
OUTLET |
Connect TEE (1) to SPOUT SHANK (2). Tighten COUPLING
NUT (3).
Connect COUPLING NUTS (4) of HOSE to each valve outlet and tighten securely.
HOT LINE FOR HELP
For
1 (800)
Weekdays 8:00 a.m. to 8:00 p.m. EST
IN CANADA
Weekdays 8:00 a.m. to 7:00 p.m. EST
Product names listed herein are trademarks of American Standard Inc. © American Standard Inc. 2002
2
4
3 | HOSE |
1