4 | MAKE WATER SUPPLY CONNECTIONS |
NOTE: FLEXIBLE SUPPLIES OR |
PURCHASED SEPARATELY.
Connect water supply to FAUCET (1) with 1/2" IPS
FLEXIBLE SUPPLIES (3) or 3/8" O.D.
Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
COUPLING
NUT
1
4
FERRULE
3
5 INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without spline is facing up. See figure "A".
Thread HANDLE BASE (3) onto DECK ADAPTER (7)
Push HANDLE (4) onto ADAPTER (1).
TOP
Find correct position of HANDLE (4) by adjusting male teeth on
ADAPTER (1) to female teeth in HANDLE (4).
Secure HANDLE (4) with HANDLE SCREW (5).
Figure "A"
Push INDEX CAP (6) in hole of HANDLE (4).
2
SPLINE END DOWN
6
5
4
3
1
7
6 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3). | 1 |
Operate both HANDLES to flush water lines thoroughly.
Replace AERATOR (3). | 3 |
|
2
M968211
