Operating Instructions, Extension pole | Holmes HASF2018RC guide

Figure 5

Step 4: Secure fan blade onto the motor shaft by turning the blade cap in a counter-clockwise direction until it is firmly in place.

Step 5: Prepare the front grill by simply snapping the

circular front grill logo plate in place.

Step 6: Center the front grill by aligning the Holmes logo so it is horizontal and parallel to the floor. Then secure the front and rear grills completely together by snapping into place. Lastly, tighten the grill screw at the bottom of the rear grill.

Remote Control Handheld Unit:

Your remote control requires 2 AAA batteries for operation. To install the batteries, simply depress the back of the remote with your thumb on the spot marked OPEN. Insert batteries according to the dia- gram shown inside. Replace cover.

Figure 4 •Do not mix old and new batteries. •Do not mix alkaline, standard

(carbon-zine), or rechargeable

(nickel-cadmium) batteries.

Final Assembly:

First, place fan head assembly onto the extension pole, lining up the fan post screw with the hole in the extension pole. Then, simply insert the fan post screw into the hole and tighten until a secure fit is obtained. Lastly, insert the tilt adjustment knob into the neck

joint and tighten in place.

Fan Post Screw

Screw Hole	NOTE: If your fan
	NOTE: If your fan
	does not have a
Extension Pole	screw hole in the
Extension Pole	extension pole

but instead has an indentation around the top of the pole; please do the following:

Step 1: First, place the fan head assembly onto the extension pole and tighten the fan post screw until a secure fit is obtained.

Step 2: Insert the tilt adjustment knob into the neck joint and tighten in place.

OPERATING INSTRUCTIONS:

STEP 1: Set fan on a dry, level surface.

STEP 2: Plug cord into any standard 120V AC outlet.

STEP 3: The speed is adjustable by pushing either the On/Spd button on the remote control, or the On/Speed

button on the touch-key pad. Push this button first for LOW, again for MEDIUM, and a third time for HIGH. Push a fourth time to repeat the sequence. To turn the fan OFF, push the OFF button on the remote control, or on the touch-key pad.

STEP 4: To oscillate the fan head, push the button marked OSC on the remote, or OSCILLATION on the touch- key pad. Push a second time to stop OSCILLA- TION.

STEP5: For a natural breeze movement, push the button marked Mode, or Mode on the touch-key pad. This will vary the fan speeds faster and slower. By pressing the Mode button a second time, or the SLEEP button on the touch-key pad, you activate the SLEEP setting. This function slows the fan speed down, and when used in conjunction with the timer settings, will ultimately turn the fan off.

NOTE: Both the BREEZE and SLEEP functions can be used with or without OSCILLATION, and start off of any initial fan speed.