ADJUSTMENT GUIDE - SPEED SETTINGS
Speed settings are
However, travel speed for the opener in both the open and close directions can be adjusted to slower speeds to minimize normal wear for heavy sectional doors.
NOTE: One piece doors are automatically set during Limits programming to the slowest speed and opener speed cannot be reset for one piece doors.
FOR
CHANGE SPEED SETTING
Use this guide to ADJUST powerhead SPEED settings.
There are three (3) Speed settings available on this unit for the open and close directions. Door type (one piece or sectional), door weight and balance, and condition of door components / track affect door speed. Speed adjustment may not be available for some installations depending on these factors.
PROGRAM
1.Press on the powerhead and hold until both
SET
lights turn steady ON. Release button.
Lights go out and Round BLUE light comes ON.
2.Press 
two times and the Round BLUE and Long BLUE lights come ON.
PROGRAM
3.Press 
once to enter the Speed Programming menu.SET The round LED will flash BLUE 3 times, then the current Speed setting for UP travel will display on the LEDs. See table below.
4.Press 
to raise or 
to lower UP Speed settings within
the available range.
NOTE: Faster door speeds may not be available.
PROGRAM
5.Press SET to set UP Speed level. The long LED will flash BLUE 3 times, then the current Speed setting for DOWN travel will display on the LEDs.
6.Press 
to raise or 
to lower DOWN Speed settings within the available range.
NOTE: Faster door speeds may not be available.
PROGRAM
7.Press SET to set DOWN Speed level. Both LEDs flash BLUE to confirm.
Speed Level
Powerhead LEDs
Round LED Long LED
Default LED display is the current Speed setting
Red 
Red
LED Speed indicator colors | Purple | Purple |
Blue 
Blue
Speed Level LED indicator colors
MAXIMUM
MID
SLOW
Red | Red |
ON | ON |
Purple | Purple |
ON | ON |
Blue | Blue |
ON | ON |
22 | ©2011 The Genie Company | 3/2011 |
